Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: OPA2197-Q1 Other Parts Discussed in Thread: OPA2197 , Dear TI Expert
In one of the reference design application ,I see OPA2197-Q1 is used as following.OPA2197 is being used for the supply for the sensor (Vin=4V) but my question what is the…
Part Number: OPA2197-Q1 Other Parts Discussed in Thread: OPA2197 Dear TI Expert
I would like to worst case analysis for voltage buffer circuit based on OPA2197...looks like following
Now I would like to calculate following worst case parameters.
1…
Hi Anthony,
I don't believe we have this information for LT1013 or OPA2205. You can use the product search to find devices that have are categorized as "Functional Safety Capable". This category of devices will have the failure mode distribution available…
Part Number: OPA2197-Q1 Other Parts Discussed in Thread: OPA197 Hi team,
My customer wants to verify what is the output voltage swing and input common mode range for OPA2197-Q1 across the full temperature range(-40 ~ 125deg)?
Thank you.
Best Regards…
Part Number: XTR111 Other Parts Discussed in Thread: INA333 , INA818 , INA333-HT , INA188 , OPA2197 , OPA2192-Q1 , TLV2197-Q1 , OPA197 I would like to design a circuit, whose signal voltage is in the range -1mV to 11mV. This signal voltage should be converted…
Part Number: OPA2197-Q1 Other Parts Discussed in Thread: OPA2197
Dear team,
In our old project we added external clamp diode as below first picture. Now in order to cost down, the customer wants to remove the external diodes, and only use our internal…
Part Number: TLV2197-Q1 Other Parts Discussed in Thread: OPA2197-Q1 , OPA2320-Q1 , OPA2192-Q1 , Hi team,
Could you please help recommend a device?
Requirements:
Vcc > 5V
Vos < 2mV
Ios <25 pA
Ib < 25pA
CMRR >105 dB
PSRR > 95 dB
Iout > 1…
Part Number: OPA2197 Other Parts Discussed in Thread: ALM2403-Q1 Hello everyone,
I'm developing a new device and I'm going to design a regulated voltage source that can be adjusted between -5V and +5V and can provide up to 50mA of current. Can I use OPA2197…
Hi Biswajit,
Here is how I interpret the OPA2197-Q1's specification.
Vs = 4.5Vdc to 8Vdc refers to low voltage specification (dual and single supply operation) in OPA2197-Q1 part. If the Vs supply voltage is between 4.5Vdc to 8Vdc, then typical PSRR…