Part Number: OPA2241 Tool/software: Where can I find detailed block diagram for the OPA2241? I can only assume it is an open collector type output with internal pullup, since it can source 4 mAmp, but sink 30mAmp. The RTN is tied to GND and no isolation…
Part Number: OPA2241 Other Parts Discussed in Thread: OPA1671 , OPA172 I'm designing a HPF for reducing the hum noise in audio signals
Even though OPA2241 has 2 internal opamp, the filter tool showing 2 seperate quantities of OPA2241 so getting confused…
Part Number: OPA2241
[Case:546632]Technical Data Inquiry for our customer.
SiliconExpert is contracted by our customer to work with their suppliers for accuracy and compliance purposes.
Please confirm if the Part "OPA2241UA" is LTB based on PDN…
Other Parts Discussed in Thread: OPA2241 Dear All,
Would you tell the details about the offset voltage of OPA2241? There is the Typ spec to the data sheet. 0.4μV/ ℃
1. Would you tell us this Max spec?
2. (If you cannot answer a question1) There…
Part Number: LP2904 Other Parts Discussed in Thread: TINA-TI , TLV27L2 , TLV2382 , OPA2241 Hello,
fare there a TINA-TI or SPICE simulation model of the LP2904 available?
Thanks and regards
Sebastian
Hello,
Although the algorithm for the tool is unavailable, we do have simulation models available that may be leveraged to see the circuit response.
I created a PSpice for TI project and ran a Monte Carlo simulation.
This is with a sample of 15…
Marek Lis said:
Please take a look at OPA187 (Vs of 36V, GBW of 550kHz) or OPA735 (Vs of 12V, GBW of 1.6MHz)
Dear Marek,
thanks for the reply, i already try to simulate this opa but unfortunatly both of them generate a working point of 10…
Hi Antek,
I will have a second reply coming. When looking at your circuit I thought the second stage only had a stability issue. The first stage also does. Below my comments are for the second stage. I will follow up with another response regarding…
Other Parts Discussed in Thread: ADS1299 , OPA2241 , ADS1298 , ADS1294R , ADS1291 , ADS1198 , TLC2272 , OPA336 Hello,
I maybe over-read some documentation and now I'm a little bit confused in how to implement the connections between the electrodes and…
