Part Number: TLV2474A-Q1 Other Parts Discussed in Thread: OPA2333 , TLV2474A , TLV9064-Q1 , OPA2333-Q1 , TLV2474-Q1 , OPA2333-HT , TLC2274-HT Hi team,
Could you recommend op amp that is pin to pin with TLV2474A-Q1 and have similar spec?
It is 4 channel amplifier…
Part Number: OPA2333-Q1 Other Parts Discussed in Thread: TINA-TI , OPA2188-Q1 , TLV2186 , OPA2333 Hi Expert,
OPA2333-Q1 was used to sensing battery voltage in BMS system. It's a design for Hydrogen energy battery. The application is show below:
Part…
Other Parts Discussed in Thread: OPA2388 , OPA2333 , TLV2333 , OPA2333-Q1 , OPA2378 Hi all,
I am looking for a P2P replacement of MCP6V02-E/SN.
Could I have your help here?
Thank you!
Sincerely,
Karen
Part Number: OPA2333-Q1 Other Parts Discussed in Thread: OPA2333 Hi, team,
In customer's circuit test, there is some ringing at OPA2333AQDRQ1 output side, they just add one 1k resistor to reduce the ringing as shown below.
Could you give some analysis…
Part Number: OPA2333-Q1 Hello ,
I am looking for some informations regading the process FAB Technology of the OPA2333A-Q1 / -EP :
-The Mask SET / The die Revision . -How we can get easily the FAB Site / The Diffusion Lot /the Wafer N°
Those requested…
Part Number: OPA2333-Q1 OPA2333AQDRQ1 One of the AMPs is not used. What should I do with the unused pins?
The current processing is:
5pin: pull down ground
6pin, 7pin connected together
Is this okay? Any other suggestions?
Part Number: OPA2317-Q1 Other Parts Discussed in Thread: OPA2333-Q1 , OPA2137 , Hi team,
Our customer is looking for low offset and EMC torelance dual opamp, because they are in trouble with the EMC test of the system.
Although they can evaluate only OPA2333…
Other Parts Discussed in Thread: OPA2333-Q1 Dear, All
The customer is considering the OPA2333-Q1. They are focused on Long-Term Stability. Long-Term Stability of Input offset voltage is described as follows. 300-hour life test at 150 ° C demonstrated randomly…
Part Number: OPA2187 Other Parts Discussed in Thread: OPA354 , , OPA2333 , OPA187 Hello,
Regarding the typical application circuit; High-Side Voltage-to-Current (V-I) Converter shown in figure 40 of the OPAx187 datasheet.
I have had some trouble getting…