Part Number: OPA2350 Other Parts Discussed in Thread: TMS320F28379D , OPA2328 , TINA-TI Dear TI, I am using OPA2350 for the ADC reference driver of TMS320F28379D. It works very well. However, it is out of stock now. Is there any alternative for it?
I understand…
Part Number: OPA2350 Other Parts Discussed in Thread: OPA2607 , OPA2365 Hello, I was using OPA2350 for an amplification stage, but now it is out of stock, I would like to ask you for a substitute or an alternative.
Part Number: OPA2350 Other Parts Discussed in Thread: DRV8412 , , TINA-TI Hi , i'am using drv8412 reference design rev.g -> dual dc or step motor driver / below is the link
www.ti.com/.../TIDM-THREEPHASE-BSDC
When i test about this evm , i wondered…
Part Number: OPA2350 Other Parts Discussed in Thread: TLV3501 , TLV3502 , OPA350 , TLV3202 Hello all,
In one of my pulsed amplifier application,
I am using the OPA2350 OPAMP as comparator to detect the RF pulsed power and put a threshold on the health. …
Part Number: OPA2350 Hello,
I have a Sallen key 2nd order filter with OPA2350 8VSSOP and 0603 0.1uF cap that is passing through noise from the switching power supply. The noise looks like a few 100 MHz cycles that happen 40 us. I was thinking to improve…
Other Parts Discussed in Thread: OPA2350 , LM358 , OPA320 , OPA350 , ADS8860 Javier,
I found the https://www.ti.com/lit/an/sbaa374/sbaa374.pdf useful ,
Now Q1: shall we use OPA2350 or LM358 instead of OP320 ?
q2: what is the different between Tidu015.pdf and…
Part Number: OPA2350 Hi,
Our customer has made a test of OPA2350 to see the influence of common-mode voltage and the input offset voltage caused by CMRR. And the inverting and non-inverting configuration are shown in TINA, as below. However, there are…
Part Number: OPA2350 I am using opa2350 as a current sensor in inverter as that combination:
and sometimes, when output voltage is >20 VAC i have problem with sensing current in negative sinusoidal:
Positive half looks quite okay. I try it with diffrent…
Thank you for the reply. Sorry for the delay. But I think OPA2227 has a very low slew rate. So, do you have any other recommendations for the opamps? How about the OPA1612 or OPA2350, or LMP8672MA? Something with a slew rate greater than or equal to 15V…
