Hello Andrew,
I am glad to hear the positive update from you. Asymmetric and unbalanced supplies do create oddities from time to time; please reconnect or ask more questions if you run into future issues.
Take care!
Best,
Alec
Part Number: OPA2670 Other Parts Discussed in Thread: OPA2673 , DEM-OPA-RGV-EVM Hi, does TI have evaluation boards that would work for OPA2670 or OPA2673?
Part Number: OPA2673 Other Parts Discussed in Thread: TINA-TI , OPA2675 Hello,
I want to define the DC voltage across the LED (Vanode - Vcathode) by 2.6V and then the signal comes over it with 400mVpp. Could you please help me to set the values? Increasing…
Part Number: OPA2673 Other Parts Discussed in Thread: OPA2677 Hi,
Could you let me know below sequence is available?
1. MCU GPIO --> A0/A1
2. 12V supply V+, GND V-
Thanks.
Part Number: OPA2673 All,
I have seen SBOA120 and was wonder if there is a similar app note using capacitive coupling; I am coupling a low data rate signal onto AC line for PLC.
Thanks,
Regards, Joe
Part Number: OPA2675 Other Parts Discussed in Thread: OPA2677 , TINA-TI , THS6222 , OPA2673 Hello,
I am going to drive a 100 Ohm twisted pair line. The input p-p voltage is around 100mV and I would like to amplify it am much as possible to keep the 100 MHZ…
Part Number: OPA2673 Other Parts Discussed in Thread: OPA2832 , LMH6612 , LMH6639 , SN74BCT25244 , LMH6611 , OPA356 Hi
We are planning to use OPA2673 for our application which have two opamp channels, we are planning to use these two channels as per below…
Hello e2e forum,
For reasons specific to the design & customer, the thread has moved offline.
For customers looking to design for VDSL2 & G.Fast variants TI recommends the THS6301 and THS6302 (for G.mgFast also).
If there is a need for higher…
Part Number: OPA2673 Other Parts Discussed in Thread: OPA2677 , OPA2670 , THS6301 To whom it may concern,
I wonder if the two 1/2 amplifiers in OPA2673 are designed only to operate in a differential fashion, or can I just use 1 of the 2 amplifiers, with…
Part Number: OPA2673 To whom it may concern,
I just want to confirm about the connections of NC pins and PowerPad.
Can NC pins be left unconnected?
Must PowerPad be connected to VS- or can it be left unconnected? (I have this doubt because PowerPad is…