Hi Arum,
Maheswari Arumugam said: I can use only one amplifier.
I think that I know what you want now. You should have posted the requirements from the get-go.
OPA2990 0-3p3 to -5to5V Vrail 04152025.TSC
Best,
Raymond
Part Number: OPA2990 Other Parts Discussed in Thread: THP210 , TINA-TI , PGA855 Tool/software: hi i need single ended to differential Converter circuit any ref design kindly suggest.
Requirement:
1.using op-amp or any other device.
2.input (0-5V ) I NEED…
Hi Shivaraj,
Luckily we do provide the thermal characteristics to make running thermal calculations possible.
Since you are wanting to use the DSG package that has a thermal pad, you are going to have a relatively low thermal resistance.
I wrote this…
Nishie-san
This is sample data for overload recovery time for output to leave VOL and rise to 50mV after that output rises at slew rate
The input voltage is ( [IN+] - [IN-] ). 10mV to 1V was tested, 1mV is extrapolated.
Part Number: OPA2990 Other Parts Discussed in Thread: CSD17585F5 , CSD25501F3 hi sir
below figure is a DC to 4-20mA circuit
Vout_A is DAC ouput
OUT1 is 4-20mA output
the output current will rasing when current over 12mA ,out of spec
did you have any advise…
Part Number: OPA2990 Our customer asked about the weight of the OPA2990IDSGR I have to see the PACKAGE OUTLINE in the data sheet did not include the weight and silicon-based transducer
Part Number: OPA2990 Other Parts Discussed in Thread: OPA990 , Hi,
I would like to know if OPA2990IDR (Dual, SOI-8) and OPA990IDBVR (Single, SOT 23) include shutdown feature.
According to pins assignments in both devices, there is no SHD pins. Does it mean…
Part Number: OPA2990 I am curious about ESD. Are the CMOS op amps more susceptible than the older Bipolar op amps? For example the OP275G (actually that one has a JFET front end).
Part Number: OPA2990 Hello TI
I would like to use an OPA2990SIDGSR (or maybe different housing type) in a circuit and therefor I would like to know, if it is possible to apply voltages of up to 30V to the OpAmps output pin, when the output ist shut down…
