Part Number: OPA310 Other Parts Discussed in Thread: OPA2310 , Hello,
for the mentioned OpAmps I'm not finding PSpice models on the web site.
What is available there are just the models for OPA310 resp. OPA2310, which
do not include the shutdown function…
Part Number: OPA310 Other Parts Discussed in Thread: TLV341A
Team,
I have been checking the DBV (SOT-23, 3x3mm) drop-in compatibility between TLV341AI DBV and OPA310SI DBV R but it seems that IN- (1IN-), IN+ (1IN+ ) And OUT (1OUT) are not pinned out the…
Hey Stefan,
What is the supply voltage? The OPA310 has fail-safe ESD protection that allows the input pins to pin larger than V+ without damaging the device. The OPA310 is a low voltage device (5.5) and the OPA170 is a high voltage device (36V). Fast Enable…
Part Number: TLV9001 Other Parts Discussed in Thread: OPA310 , OPA2310 Hi team,
I would like to check with you, if we have the data for input impedance for TLV9001? I could see OPA310 has the both resistance//capacitance but I can only find input capacitance…
Part Number: OPA357 Other Parts Discussed in Thread: REF3030 , , TLV9101 , OPA310
Hello,
I'm using an OPA357AIDBVR (IC18) to buffer a REF3030 chip. Below I show all the circuits that have interface with the AVREF: The problem: the AVREF should follow…
Hello,
You are correct in that adding a feedback resistor to a buffer circuit will not help the performance.
Generally, external input bias current compensation was more common for bipolar devices with IIB in the range of tens of nA. Modern CMOS amplifiers…
Hey Sebastian,
As far as op amps go, there are a few devices that do not have a diode to V+, but almost all will have a diode to V-. I'm not sure if this is part of your requirements. LM2904B-Q1 does not have a diode to V+ and is able to see up to 40V…
That 100 mA value is the absolute maximum rating, i.e., the current at which the device can be damaged.
As shown in figure 6, this device will not be able to output more than about 15 mA with a headroom of 1 V to the supply:
The OPA310 would be strong…
The specified minimum is 1.8 V. Below 1.8 V, the electrical characteristics are no longer guaranteed. If this device had been designed for a nominal 1.8 V supply, it would have a specified minimum of 1.7 V or 1.6 V.
If you cannot use a higher supply voltage…