Part Number: OPA322 Other Parts Discussed in Thread: TINA-TI Hi,
Please see my below design and suggest is there any improvements required.
The photo diode used in this design is MPN : S2386-5K from Hamamatsu.
Will it work properly for very low currents…
If you power the OPA322 with +/-2.5V, then you must not give +3.99V to the input. As the input voltage being higher than the supply voltage, this will destroy the OPA322.
Also, as being powered by +/-2.5V, the output voltage of OPA322 can never become…
Part Number: OPA322 Other Parts Discussed in Thread: TINA-TI Hello,
I am designing the following basic photodiode current sensing circuit. I am holding my common mode voltage at 100mV and my resistance is 480MOhm. My goal is to be able to operate with…
Part Number: OPA322 Other Parts Discussed in Thread: LMC6001 Hello,
i want a design where i can measure 1 Channel in a Range from 1pA ..... 1µA with 1pA Resolution and <1pA Accuracy. Is the opamp OPA322 sufficient for this application and which outside…
Part Number: OPA322 Other Parts Discussed in Thread: OPA320 I compared the two. The main difference is OPA320 has lower offset. And OPA322 have quad version. And are there any other differences I missed?
Thanks.
Part Number: OPA322 Hi Sir,
My customer would like design OPA322AIDBVR
Would you please review U1209 OPA322AIDBVR schematic and layout and provide your comment?
https://txn.box.com/s/6e64d0rixvn2a8e5mqbi7xkdsdegfj73
layout viewer
https://txn.box.com…
Part Number: OPA322 Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models
this is a simulation result of OPA322S from TINA-TI.
I think it's error that VP_10 should =VP_12=1V, and VP_9=2v which is simulation result of OPA322…
Part Number: OPA322 Hi,
I am learning the PSRR of OPA.
and Why use the circuit to test PSRR of OPA?
in lab test, we need to Amplify VOS to measure
But why need to adjust V1 for Vout=0? to In order to prevent the open loop gain from bringing errors?
Could…