Part Number: OPA342 Hi team,
The customer needs the material information for OPA342NA/250 with SOT-23 package.
Would you send it to me?
Best Wishes, Mickey Zhang Asia Customer Support Center Texas Instruments
Other Parts Discussed in Thread: OPA342 Hi
Can I use an OPA342 in a peak detector circuit like this :
http://en.wikipedia.org/wiki/File:PeakDet.svg
Can it handle an input differential voltage of 5V (with +5V single supply) ?
Thank you.
Other Parts Discussed in Thread: OPA342 Hello team,
I am looking for an Op Amp where the V CM can go somewhere in between 200 and 300 mV below the Negative Voltage Supply, and it should apply over a temperature range -40°C to 85°C
Other relevant…
Other Parts Discussed in Thread: OPA2314 , OPA2340 , OPA340 , STRIKE , OPA313 , OPA314 , OPA344 , OPA343 , OPA342 The drawing below shows an OPA2314 in a constant current control circuit.
When the +5V supply is turned on, the DAC puts out 0.07V (0.7V and 0.8V are…
Other Parts Discussed in Thread: OPA342 OPAx342 datasheet does not give a range for acceptable values of the gain resistors. For example, if I used 649k and 200k, is that acceptable, or is 65k and 20k recommended? Datasheet has a range for RL of 100k to…
Thanks for the quick responses Bruce and Mohammad. It appears that the op amp was defective. After replacing it and setting R3=R2=20K, the gain was measured at just under 2. However, setting R3=100K did not increase the gain to 6, but only increased the…
Other Parts Discussed in Thread: OPA320 , OPA342 , OPA376 I'm looking for the
photodiode preamplifier for a useful frequency range of at least 0-100 kHz with
incident light powers of 10 nW. The chosen
diode for this
application is model
FDS100 …
