Search tips
Showing 106 results View by: Thread Post Sort by
    Answered

  • OPA354: OPA354 maximum input ratings

    Resolved
    Part Number: OPA354 Other Parts Discussed in Thread: LM7705 Hello, in an old datasheet of the OPA354 there is the following phrase in the maximum ratings: "Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more…
    • Resolved

  • OPA354: LTspice Stability Simulation of OPA354 – Unexpected AOL Results

    Part Number: OPA354 Tool/software: Hello, I am trying to run a stability simulation in LTspice for the OPA354 differential amplifier, following the method shown in TI’s training presentations. The goal is to extract the phase margin by plotting Aol…

  • RE: OPA354: OPA354

    Hi Ignacio, you are right, I got confused between the SiPM and the TIA input. In the configuration I need to implement, the SiPM sources current on the anode, while the TIA input sinks current; therefore, the IDC_EN pin should be set high. This is very…

  • OPA354: Spice Model for OPA354 simulation

    Part Number: OPA354 Tool/software: Hi, I am using spice model from TI for simulation of the OPA354 amplifier, I am finding some problems to understand the results: 1) using dual power supply +/-5Vdc I will find 7mV of Off-Set in the output signal…

  • OPA354: Please help to suggest High-speed Op-amp part for sense current waveform

    TI Thinks Resolved
    Part Number: OPA354 Tool/software: Hi, Customer looking for amplifier Rsense signal of circuit below by using High speed Op-amp. The circuit and waveform in picture below. Please you help to suggest TI Single package for High-speed op-amp for this…

  • OPA836IDBVEVM: I need the EMIRR tested performance of this Op amp to compare with the OPA354

    Answer Suggested
    Part Number: OPA836IDBVEVM Other Parts Discussed in Thread: OPA354 , OPA836 Tool/software: The OPA836 is in our product currently and is showing high sensitivity to the cell phone frequency range. We need a replacement and are considering the OPA354.…
    • Answered

  • OPA209: Can OPA209 or OPA354 replace OPA350 for DDC264

    Resolved
    Part Number: OPA209 Other Parts Discussed in Thread: OPA350 , , OPA354 , DDC264 , OPA328 Hi team, Could you please kindly help check if OPA209 or OPA354 replace OPA350 for DDC264? Thanks, Brian
    • Resolved
    • Answered

  • OPA354: Test circuit for Figure 1 (Typical Characteristics) in OPA354

    Resolved
    Part Number: OPA354 Hi Team, Good day! Our customer is requesting for the test circuits used in obtaining the Bode plot in Figure 1. (Noninverting Small-Signal Frequency Response) of the OPA354 datasheet. Is it possible to provide this information…
    • Resolved

  • OPA354: About Open-Loop Gain and Phase test

    Part Number: OPA354 Hi, Could you tell me the test circuit and conditions when you get the graph below? I want to make use of the circuit and conditions that can realize the characteristics of this graph in the design. And I want to test at TINATI. …

  • WEBENCH® Tools/OPA354: bandpass filter design tools

    TI Thinks Resolved
    Part Number: OPA354 Tool/software: WEBENCH® Design Tools Hi, I want to find a tool to help me design the bandpass filter, but I can't find the access. Both the WEBENCH and Filter pro. So, can you give me the access? Thanks!

Didn't find what you are looking for? Post a new question.