Hello Maged,
Thank you for your patience. We reviewed your design and requirements, and have a few comments and suggestions.
Looked into the waveform generator, and it has a voltage output between 38mVpp to 0.65Vpp with a max frequency of 12.5MHz…
Part Number: OPA992 Other Parts Discussed in Thread: ADS7961 , , LM7705 , OPA2810 , OPA355
For our design, we have 16 channels and connect to ADS7961, as this picture:
I read here design for photodiode TIA:
https://www.ti.com/lit/pdf/tidu535 …
Part Number: OPA695 Other Parts Discussed in Thread: TINA-TI , OPA691 , OPA355 Hello, recently I'm making a negative impedance circuit with OPA695 (working frequency at 20MHz).
I imported the OPA695 Pspice model to the ADS 2020 update2.0 for PCB electromagnetic…
Hello Jonathan,
Based off the specified parameters specified alone, OPA355/6 or THS4631 seem to be suitable options. Is there a bandwidth requirement? As Kai mentioned a schematic would be helpful.
Best,
Hasan Babiker
Part Number: TLV9161-Q1 Other Parts Discussed in Thread: OPA2607-Q1 , OPA355-Q1 Can you suggest high side current sensing op amp with higher band width (above 4MHz) and higher common mode voltage (above 12V ); Supply voltage is 5V(+V)
no RRIO Buffers that I know of, so you are looking at a 5V RRIO op amp with enough speed to operate gain of 1 at what you need,
consider
OPA355
OPA810
there are others as well,
Part Number: OPA2301 Other Parts Discussed in Thread: OPA355 , TINA-TI I have OPA2301AIDs and tried to make a voltage follower but WEBENCH reminds
In the datasheet there is G=1 but no Rf=0. It seems OPA2301 is not able to make a voltage follower.…
Hi Jim,
Thanks for your reply.
20mV signal is with respect to ground, there is no DC offset. It can be AC coupled as there is no DC component in the signal. As of now we are planning to use OPA355 OP-AMP to driver the signal at the input of ADC. Actual…
Part Number: OPA356-Q1 Other Parts Discussed in Thread: OPA354 , OPA355 , LMH6611 , OPA356 , THS3120 , TINA-TI , BUF602 , LMH6722-Q1 Hi
Our customer are considering that this device can drive coaxial cable at the following input conditions.
- Fin…
