Part Number: OPA396 Other Parts Discussed in Thread: OPA391 , , TLV9001 Tool/software: Hi,
I would like any suggestions for a TI replacement for MAX9914 ?
Max9914 is a bit expensive.
The dollar in my country is very high.
Preferably sc70 or sot23-5 package…
Part Number: OPA396 Tool/software: Hi There,
OPA396DCKR, OPA396DCKT, TLV9302IPWR
Could you mentioned that how many reflow cycle that the above parts could withstand.
Regards
Jeya
Part Number: OPA396 Other Parts Discussed in Thread: OPA391 Hello?
I looking for the op-amp using noninverting amplifier and voltage follower.
I saw OPA396, a new product with a precision chip, and the datasheet(JULY 2021) seems strange.
In 'Figure…
Hi Hironari-san,
Hironari Ishiguro said: But at the very low input voltage suvh as a few mv, the output didn't get exactly same voltage as input.
The LMP7702 has typical output voltage from 30mV up to 170mV (worst case), and it is not suited for low…
Hi Rajesh,
You could use the OPA391 or cost-down option OPA396. The AOL is specified for output swing 100mV from either rail for light loads.
In this case, you can swing from 0.1V to 3V for your ADC input voltage.
See updated circuit below.
Regards…
Part Number: XTR117 Other Parts Discussed in Thread: LM2902 , TLV9001 , LMV321A , , OPA392 , OPA391 , OPA336 , OPA396 Hi Team,
I am using XTR117AIDGKR as a current transmitter(4-20mA) for a position transmitter.
So kindly verify and let me know your comments …
Part Number: TLV4333 Other Parts Discussed in Thread: OPA397 , OPA396 , OPA392 , OPA391 , OPA320 , OPA196 , OPA325 , OPA191 Hi Team,
I have two question want to ask.
Can the op amp be used as a comparator? Can the tlv4333 op amp be used as a Hysteresis comparator…
Part Number: TLV2333 Other Parts Discussed in Thread: OPA397 , OPA396 , OPA392 , OPA391 , OPA320 , OPA196 , OPA191 Hi
My customer is using TLV2333.
The input differential voltage is 2V, but the graph below is expressed only up to 800mV. I want to know the input…
Hi Ohad,
The OP07 is a good, low-cost amplifier, but does have limited input and output range capability (input common mode needs to be 2 V higher than Vcc-). Depending on the input common-mode voltage, it may not work. Typically, for operation at 3.3…
