Part Number: OPA548 Other Parts Discussed in Thread: , OPA541 , OPA549 Hi TI,
I had a question regarding the OPA548 OPAMP, I'd like to use it to drive a laser diode to output 4A. But my wrinkle is that the operating time is 2seconds ON & 48seconds OFF…
Part Number: OPA548 Other Parts Discussed in Thread: THS3470 , TINA-TI As shown in the figure, the output of OPA548 is abnormal. What is the reason for this? In addition, if I need to obtain a sine wave signal with an amplitude of 60Vpp at any frequency…
Part Number: OPA548 Hi, I need to test an electronic module for automotive application (12V) and would like to evaluate the behavior on the bench under sine ripple from few Hz up 200kHz, up to 6Vpp. As far as I could see, OPA548 could solve this problem…
Part Number: OPA548 Hi,
My cusotmer is using current limit of OPA548 in their design.
What is the settling time to limit the output current?
Best Regards, Taki
Part Number: OPA548 Other Parts Discussed in Thread: OPA187 , , OPA827 Tool/software: Hello, Please find attached a diagram using a Howland current pump. Input voltage +/-10V Output current +/-12mA Resistive and inductive load connected between Iout and…
Part Number: OPA548 Dear the Technical Support Team
My name is TAKUMI ABIKO.
Iam currently using your product and would like to request a technical inquiry regarding the following component.
Component Type:OPA548T
I would appreciate it if you…
Part Number: OPA548 Hello,
My custotmer has an qestion for the below figure which comes from the OPA548 datasheet. They would like to know the reason of 10uF (yellow marked). What is the purpose of it? Is it like a noise filtering of a specific frequency…
Part Number: OPA548 Other Parts Discussed in Thread: OPA859 Hi,
I download the Pspice module available in Ti. But while importing in LTspice the module didn't Work for me.
If any high output current with high bandwidth Op Amp available similar to…
Part Number: OPA548 Other Parts Discussed in Thread: OPA192 Hi, We are searching for suitable OP-AMP to drive the MOSFET(Gate charge-95nC), the switching speed should be 1KHz to 1MHz and the Slew rate should be 200ns and output current should be more…
