Part Number: OPA596 Tool/software: A month ago I asked when the OPA596 spice model would be available & when the part would be available for purchase.
I used the TI-TINA model, but the part is still not available for purchase. I cannot proceed with…
Part Number: OPA596 Other Parts Discussed in Thread: OPA2596 Tool/software: Hello,
1. Is - the OPA596 - works with 0V at the positive PS and -65V at the negative PS.
2. Is there a spice model for it.
3. When we can buy the dual - OPA2596.
Regards,
Gi…
Part Number: OPA596 Other Parts Discussed in Thread: OPA593 , OPA593EVM Tool/software: Hi:
Is an OPA596 Cadence PSPICE Model available?
Will the OPA596 function is this operating range?
My operation range is:
V(-)=0 to V(+)=5V
V(-)=0 to V(+)=50V
The…
Part Number: OPA596 Other Parts Discussed in Thread: OPA392 Tool/software: Hi team,
Sorry that I am not sure how to filter out the correct product meeting the needs below on the website
Could you please help suggest a suitable solution meeting below…
Part Number: OPA541 Other Parts Discussed in Thread: TINA-TI , OPA596 , OPA593 Tool/software: Hi,
Attached below is my design of the Improved Howland pump to drive magnetic coils, I would like to know if it is stable.
System requirements : current ->…
Hi Cezar,
Please provide me a drawing or schematic (hand sketch will do). Including your load and current sensing element.
I am happy to provide you with a simulation, but I need to know what you want. H-bridge in current flow can be configured many ways…
Part Number: PGA281 Other Parts Discussed in Thread: TIPD125 , , OPA596 , INA592 , INA240 Tool/software: Hi Team,
I am looking for high side current monitor solution to measure ~10uA level current at 48~60VBUS.
The close solution I find is the reference…
Hi Michal,
Michal Tyc said: We are trying to verify the behavior of a supply-bootstrapped circuit using OPA828 in a TINA simulations.
The op amp bootstrapped technique is typically implemented in operating at high voltage of a given op amp. OPA828 is ±18Vdc…
Hi Arabella,
Arabella Zhang said: Can Flag PIN of OPA551 be NC?
The customer can leave the Shutdown Flag pin open, if it not used. Figure 27 indicates that the pin driving a resistor is optional.
Normally, a current source should connect to some load (e…
Part Number: OPA569 Other Parts Discussed in Thread: OPA596 , I’m driving a laser diode with this opamp (single supply) and monitoring it using the Imonitor pin with a 400ohm pull-down to ground.
I’m aiming for a 95mA output which requires just over…
