Search tips
Showing 119 results View by: Thread Post Sort by
    Answered

  • OPA695: The unit for "Noninverting input current noise" spec is incorrect

    Resolved
    Part Number: OPA695 The unit for "Non-inverting input current noise" specification is incorrect, it it should be "pA/√Hz" instead of "nV/√Hz", according to Figure 13 in the datasheet.
    • Resolved

  • OPA695: noise behavior of the device down to low offset freq?

    TI Thinks Resolved
    Part Number: OPA695 Other Parts Discussed in Thread: OPA859 , LMH6702 Hello, The OPA695 was used in a low phase noise amplifier configuration for a 10MHz / 100MHz system clock distribution circuit. Studying the datasheet, all noise sources (noise voltage…
    • Answered

  • OPA695: Pspice model for RF simulation

    Resolved
    Part Number: OPA695 Other Parts Discussed in Thread: TINA-TI , OPA691 , OPA355 Hello, recently I'm making a negative impedance circuit with OPA695 (working frequency at 20MHz). I imported the OPA695 Pspice model to the ADS 2020 update2.0 for PCB electromagnetic…
    • Resolved
    • Answered

  • OPA695: Input Voltage Noise at <1KHz

    Resolved
    Part Number: OPA695 Other Parts Discussed in Thread: LMH6702 , THS3491 Hi Team, Figure 13 in the datasheet shows the input voltage noise characteristics of OPA695 from 1kHz to 100MHz. Our customer would like to request for its input voltage noise characteristics…
    • Resolved

  • OPA695: OPA695, OPA2695 unity gain stability

    Part Number: OPA695 Other Parts Discussed in Thread: OPA2695 , , BUF602 , LMH6559 Hi Experts, My customer would like to use OPA695 or OPA2695 by unity gain. Does these devices can be stable operation at unity gain? I saw datasheet, OPA695 does not show a…
    • Answered

  • OPA695: Output abnormal when temperature increases

    Resolved
    Part Number: OPA695 Other Parts Discussed in Thread: OPA690 Hi expert, My customer use OPA695 and find some of them output abnormal when temperature increases. Please see schematic and waveforms in attached pdf. OPA695测试.pdf Regards and thanks. Jiando…
    • Resolved
    • Answered

  • OPA695: Die difference

    Resolved
    Part Number: OPA695 Other Parts Discussed in Thread: OPA684 Hi team, A customer want to confirm the difference of CLC401A and CLC401. can you help me to clarify it? Thanks. Regards,
    • Resolved
    • Answered

  • OPA695: Is there a power-on sequence requirement when the OPA695 is powered by dual power supplies? Thanks！

    Resolved
    Part Number: OPA695 Is there a power-on sequence requirement when the OPA695 is powered by dual power supplies? Thanks！
    • Resolved

  • OPA695: I want to amplify the voltage signal from 7mv to 1000mv voltage signal

    TI Thinks Resolved
    Part Number: OPA695 I have already used opa695 to amplify signal to 100mv. But I need to make the further amplify. What Can I do to finish my project? What parameter I can change to get the effect I want?
    • Answered

  • OPA695: Power Supply for EC table

    Resolved
    Part Number: OPA695 Hi Team, The electrical characteristics table doesn't point out the power supply, may I know the power supply, is it single supply or dual supply? Is there the EC table with single +5V power supply? Thanks and Best Regards! …
    • Resolved

Didn't find what you are looking for? Post a new question.