Part Number: OPA856 Tool/software: Hey guys, I was adding this part to my parametric database and wondered about a couple of things,
Here is a typo on slew rate, the spec tables shows 375V/usec I think,
Also, looking at the input impedance, it seems…
Hello Simon,
I discussed your OPA856 approaches with my team. I do not see an issue using multiple OPA856 stages into a comparator stage.
You can proceed with your design, as it continues to work for your application.
Best,
Alec
Part Number: OPA856 Other Parts Discussed in Thread: LM828 , LM27761 , TPS60400 Hi ,
I'm using OPA856 Op-amp in my simulation as error amplifier. In this op-amp i need to give Negative Voltage supply for VS– Pin,
Here i've choosen LM828 (Switched…
Part Number: OPA856 Other Parts Discussed in Thread: TINA-TI Dear all,
Would you please help me to plot SNR (Signal to noise ratio) in TINA TI for the following circuit? it is an transimpedance amplifier:
What procedure should I follow in the post processing…
Part Number: OPA856 I was kind of reviewing this newer part, and noticed this in the text discussion. The spec table and front page say 350V/usec, which seems right for the quiescent current, so this is probably an error here.
Part Number: OPA856 Other Parts Discussed in Thread: TINA-TI Hi Team,
Our customer would like to know the propagation delay of the OPA856 as it is not stated in the datasheet. I have searched the forum but it seems that opamps that are configured as comparator…
Hi Andreas,
Andreas Dierks said: So this means to me that using the OPA85X OPAmps is not possible in the concidered configuration for switching between the different low pass filter pathes and relais or multiplexer (like TMUX1109) have to be used. Correct…
Part Number: OPA856 Hello,
I want to simulate a OPA856 with a buffered voltage divider as shown in the picture below. The desired gain is ~5600 and the capacitator was dimensioned to create kind of a bandpass between 3 and 19kHz. As single supply is used…
Part Number: OPA856 Other Parts Discussed in Thread: BUF602 , OPA695 Hello Experts, My customer would like to design a voltage follower circuit for 90MHz sinewave input signal(3~4Vpp). I think OPA856 is one of candidate, but I would like to ask you that…
