The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: OPA862 Tool/software: I see the power down mode shuts the outputs off and goes to a low power mode but it doesn't say anything about the outputs in that mode. Are they pretty much high impedance or open collector except for steering…
Part Number: OPA862 Tool/software: This is a nice tool, but I have a few needs it doesn't meet: I need to build a filter for a differential signal. You can do this with the MFB configuration and a fully differential amp. You can convert a single-ended…
Part Number: OPA862 Other Parts Discussed in Thread: OPA892 Tool/software: The signal input to the OPA862 is generated by an oscillator. The circuit generated by the ICM7555 had differential outputs. On the other hand, the circuit generated by the SIT2001BC…
Part Number: OPA862 Tool/software: It is not a differential output. Signals in-phase are output. What is the cause?
CH1：DIFF_OUT_N
CH2：DIFF_OUT_P
CH3：DIFF_IN
Part Number: OPA862 Tool/software: I want to use opa862 as a differential adc input driver. My signal is in the range of 0-5V and the ADC input range is 0-2V.
So I conducted a Tina simulation using opa862 as an inverting amplifier.
The results of the…
Part Number: OPA862 Other Parts Discussed in Thread: THP210 , THS4531 , I've got several OPA862s in a design. In practice, I haven't needed the speed, and have seen some sporadic oscillation from the parasitic capacitance. Is there a pin compatible, slower…
Part Number: OPA862
2023-03-24 16:40:54 CDT - Mark Philip Felipe
Customer Response
Hello John, Also you can call me on my cell phone: 847 890-0637
In the datasheet on page 5 it says that input Current(I) bias is 1u amp for A1 block input…
Part Number: OPA862 Other Parts Discussed in Thread: TINA-TI Hi~.
It was configured the same as OPA862 DATASHEET 19PAGE (Figure 7-4. Typical Single-Supply Configuration), and PD=GND was connected. However, the output does not 2V/V and a negative value…
Part Number: OPA862 Other Parts Discussed in Thread: OPA855 , OPA846 OPA862 application includes photodiode amplifier. However, data sheet indicates an input bias of IB Input bias current, A1 = 3.1 µA. That seems unusually high for this sort of app…
Part Number: OPA862 Other Parts Discussed in Thread: INA210 , ADS52J90 , , THP210 , THS4561 , THS4509 Dear team,
We are looking for SE to differential amp for our application.
Our input signal is INA210 and use ADS52J90 to monitor system current information…
