Part Number: OPA990 Hi,
I am using the OPA990SIDBVR as a buffer. my VCC is 12V and my input voltage is 12V also.
This OpAmp is just for driving a FET (DC, not PWM). The FET has Gate to source resistance of 1Meg.
If i enter the OPA990S to shutdown mode…
Part Number: OPA990 Dear:
current, OPA703NA is used in PCB,but I want to replace OPA703NA with OPA990IDBVR directly ,no change schematic, is it ok ? any influence in the function ?
Part Number: OPA990
Dear, Support Team.
The OPA990 data sheet says "DRL package is preview only".
Will it be released?
If so, when will it be scheduled?
Best Regards,
Mariko Okutsu
Part Number: OPA990 Other Parts Discussed in Thread: OPA170 , It seems as if the pinout may be wrong. Our input to the + on pin 1 is being crushed (to 0V) when we enable the Op Amp (/SHDN goes low, which should be off, but their naming is wrong and low…
Part Number: OPA990 Other Parts Discussed in Thread: TLV9101 , Hi Team, Our customer noticed that the pin assignments and drawings of the OPA990 and TLV9101 SOT-23 6-pin package were not properly matched on the datasheet. They've experienced an issue designing…
Part Number: OPA990 Other Parts Discussed in Thread: OPA991 Hi sir,
Please kindly recommend TI P-P solution to replace NCS21911 SOT-5P.
Other spec requirement is:
Offset: 25uV-800uV
VCC: +36V (at least >16V)
Thanks a lot!
BR,
Sean Liao
Part Number: OPA170 Other Parts Discussed in Thread: TLV9101 , OPA990 , TL081H
Hi, this is my new thread in relation of my other thread ( OPA170 Abnormal Behaviour ).
My setup (use as current sensor : V2 connecting V3 with ~0.1 ohm;150C test)
V1 = 12V, V3…