Part Number: PGA308 Tool/software: Is there a document showing the PCB footprint for the DRK package for the PGA308? The data sheet and package drawing do not show the actual recommended footprint. I did download it from Ultra Librarian (direct link…
Thank you Ashley. I knew better and still goofed that up. I appreciate your attention to detail. I do get 0.5 and 4.5 as expected when I reverse the leads and (correctly) flip the mux bit.
Hey Keith,
I finally have confirmation that the 3.87mm value is the correct width. Again, I appreciate your patience here, as many people have been OOO. I have also submitted a request to get this package drawing updated with the correct value.
Best, …
Part Number: PGA308 Other Parts Discussed in Thread: TDC1000 Tool/software: dear sir
our customer want PGA308 with TDC1000 due to very pricision output control.
for test, customer 2MHz sensor signal input to TDC1000, unfortunately, PGA308 output can…
Part Number: PGA308 Other Parts Discussed in Thread: INA333 , PGA309 Tool/software: Hello TI Support Team,
We are currently experimenting with the PGA308 as a replacement for an INA333. The goal is to change things like offset and gain without additional…
Part Number: PGA308-Q1 Other Parts Discussed in Thread: PGA308EVM , PGA308 , PGA309 Tool/software: Hi Team,
My customer is looking at the PGA308-Q for a strain gauge.
I’m not very familiar with the 1W interface. I read through the datasheet and manual and…
Part Number: PGA308EVM Tool/software: I do not find a jumper table in any of the pga308evm documentation on how to set up the test board to program an external stand alone packaged sensor .
What jumpers must be set and what position as well as what terminals…
Part Number: PGA308 Tool/software: Good morning Support Team,
I found the following stated on the datasheet:
Linear input range is the allowed min/max voltage on the VIN1 and VIN2 pins for the front-end PGA to continue to operate in a linear region. The…
Part Number: PGA308 Hello,
I'm working with a pair of PGA308s that we communicate with using a couple GPIOs of an STM32. During ESD testing we're seeing a loss of communication via the 1W link. Was curious if anyone else with experience with this part…
Part Number: PGA308 Other Parts Discussed in Thread: PGA309 Hello Team,
during my investigation I did not find any usefull comparison between the PGA308 and PGA309.
I know, I don't need any external EEPROM for the PGA308 but I don't know anything about…
