Part Number: DRV2700EVM-HV500 Other Parts Discussed in Thread: DRV2700 Hi, I'm Jeon Hyeon Min.
I'm using DRV2700EVM-HV500 for driving piezoelectric actuator.
What I want is 0~158V AC sine wave output for 0~200Hz using DRV2700EVM-HV500.
So I found…
Part Number: DRV2700EVM-HV500 I'm running windows 10 and trying to connect to my DRV2700EVM-HV500 but the device is not recognized by piezo control console. When I try to follow the firmware update/scan device procedure the board doesn't show up, I just…
Part Number: DRV2700EVM-HV500 Hello,
I set the waveform as the picture billow using Piezo Control Console . I want this waveform to be output only once when I click "Send Waveform". But the waveform was output 4 times. What caused this to happen…
Part Number: DRV2700EVM Hi all,
I am trying to use PiezoControlConsole.exe to drive DRV2700EVM DRV2700EVM but my laptop cannot recognize DRV2700EVM. From the GUI, the USB button is blank like this:
My laptop system is win10. I tried to update the firmware…
Part Number: DRV2700EVM Hi Ivan,
The customer installed the Piezo Control Console bit it doesn't work with Windows 7 Enterprise Edition. Does it support Windows & Edition?
Regards,
Danilo
Hi Sydney,
Thank you very much.
I closed JP13,
I enabled output via the Piezo Console.
And with a multimeter I measured 22V between OUT +/ -.
This gives you a small sign of operation.
However, my Jumpers JP7, JP8, JP9 are
In EN/MSP
GAIN 1/MSP…
Part Number: DRV2700EVM Hello
I started the testing of this module with the delivery configuration, however:
The Piezo Console software detects and recognizes the module, but it crashes when I press "Connect".
I updated the module firmware with…
Part Number: DRV2700EVM Hi all,
I was trying to test the DRV2700EVM following the procedure on the User Manual.
On the GUI, however, the connect button was grey. I tried on Win 7 and Win 10 but none of them recognized the device.
Could you please help…
Part Number: DRV2700EVM Hi experts:
I'm trying to drive my piezo speaker with DRV2700EVM, but Piezo Control Console crashed when I click console, my PC OS is Win7.
if I use analog input by an external signal, just connect JP7,JP8,JP9 to PU, remove jumppers…
Part Number: DRV2700EVM I have tried downloading the Piezo Control Console on a variety of devices and all of them are outputting the same error message when I attempt to connect the board to the computer. I want the board to be able to boost an AC signal…