Part Number: DIP-ADAPTER-EVM We are planning to use your evaluation board to validate a new fabrication process.
Is it possible to get access to the Gerber for the pastemask top layer?
We could work with any part of the layout file that shows the top…
Part Number: SMALL-AMP-DIP-EVM Hi
Can you please provide the CE/EU Declaration of Conformity for SMALL-AMP-DIP-EVM?
This product appears to bear the CE-Marking but the EU D eclaration of Conformity is not available on the website.
Thank you
I apologize for the confusion. Initially, I tested the TF-A patch you provided on the AM62L EVM. However, I incorrectly configured the DIP switch, causing the system to stall at the U-Boot/SPL stage. Yesterday, upon realizing the DIP switch error, I adjusted…
Part Number: DRA821U Tool/software: Hi there,
We cannot boot from OSPI on our custom board so we tried the same procedure on J7200 EVM board and it doesn't work either. Can you check the following steps and see if we misses something or made some mistakes…
Hi,
I think I understand the system a bit better now.
On the EVM OUt1 and OUT2 have pull ups. Try depopulating the highlighted resistor pull ups and make sure the the DIP switch is connected to the LED:
Hi Hong!
We're using the reduced pincount for the bootmodes and we have the 4 pins available on a dip switch just like on the EVM. The default bootmode with weak resistors is eMMC with SD-Card as backup.
We have all the boot media available except…
Hi Kavaskar,
KAVASKAR S said: How can I configure the DIP switch settings on my LP-AM2434 to enable it?
On LP-AM243, you do not have an option to switch to Ethernet boot mode (limited dip switches are not available on an LP compared to the EVM).
If you…
Thanks, Tim. For the replay. I understand your explanation as documented in the EVM manual. We believe we have the correct dip switches. I have attached a picture of the EVM showing the dip switch and jumper settings. Can you have a look and let me know…
