But when I use only one I2C control its still cannot set Hi-Z snd then amp on.
The figure is not connect to the EVM, and the sample rate shows error, when I connect to the EVM, apply config., and play the music in 48kHz, the sample rate is still error…
Hi Yuxi,
We've given layout guidelines and snapshot in section 7.4 of the datasheet.
We've also provided the schematic in the EVM's user guide: https://www.ti.com/lit/pdf/slau904
The ADC noise floor wont degrade the SNR performance since it is much…
Part Number: AMC3330EVM Other Parts Discussed in Thread: AMC3330 Hello,
I am using AMC3330EVM board in an Hardware In the Loop (HIL) test bench, to emulate voltage sensor and feed the control board.
Application context : motor control with PWM inverter…
Dear Javier,
Thank you for your support.
I have other questions.
My customer bought TQL50A samples from Topstek. and disassembled image is as below.
As you see there is hall device in the gap of magnetic core.
Could you check that how can…
Part Number: TAS2320 Other Parts Discussed in Thread: TAS2780 , TAS2110 , TAS2120 , TAS2770 Tool/software: Hi, TI expert
We have a CLASS-D audio amplifier IC recommendation inquiry from a customer suitable for driving an 8 ohm 3W single-channel speaker…
Hi, In GUI there are no errors, But red fault led gets on EVM.
1) As per your instructions we tried to change and update registers but values are not updating.
2) We have set voltage to 12v and 5 amp so there is more than enough power to make…
Hi Michael,
Are you referring to the spec below in the EVM user guide? This is just stating you should use a power supply capable of 8 A if you want to evaluate the full capabilities of the amplifier. The amp will not always consume that much current…
Part Number: TPS25730EVM Tool/software: HELLO,
I try to configure the TPS25760D with the EVM module as follow:
- ADC1 SW position to 1 for 5 V minimum input voltage (34..30mV mesured at the center point the resistor divider network)
- ADC2 SW position…
Alvaro,
When I hear that mechanical vibrations cause an electrical disturbance, the first thing that comes to mind is "microphonics". This is a change in capacitance caused by mechanical vibrations. The capacitance change generally translates into an…
Hi Paul,
the characterization with the TAS2563 does require the Smart Amp learning board 2. PP-SALB2-EVM Evaluation board | TI.com
the "characterization Wizard" will be only visible in PPC3 when this is attached to the EVM.
Regards, Arthur
