Other Parts Discussed in Thread: SN65HVD251 , SN65HVD1040 , SN65HVD253 , SN65HVD252 Hi all Would you mind if we ask SN65HVD251, SN65HVD1040? We'd like to confirm about SN65HVD251, SN65HVD1040. Are these device avilable to used for DeviceNet? Kind regards…
Part Number: SN65HVD1040-Q1 Other Parts Discussed in Thread: SN65HVD1040 I have several PCB modules connected to common CAN bus
Some PCB module operate on 3V3 power bus (no 5V) and some operate on 5V0 power bus
How the CAN transceiver handle this…
Other Parts Discussed in Thread: SN65HVD1040 I am looking at the SN65HVD1040 data sheet and noticed a peculiar spec. The Recommended Operating Conditions show only a Junction temp of 150°C and the rest of the specs are defined as over recommended operating…
Other Parts Discussed in Thread: SN65HVD1040 I have 2 can boards with sn65hvd1040 transceiver. One board reads data from the sensors then it sends the data to another board via CAN, the other toggle the state of relays according to sensor data. For power…
Hi,
We found a description of a way of termination of SPLIT pin in Figure 15 in datasheet.
According to the datasheet, Vsplit = 1/2 Vcc in normal mode, floating in other modes.
What is the normal mode?
When we use it in high-speed mode,…
Other Parts Discussed in Thread: SN65HVD1040 Hello,
I have 4 pcb boards that all do not communicate on the CAN bus when the SN65HVD1040 driver is setup with the split function on these boards.
The resistance between CAN-H and CAN-l pins on the board…
Other Parts Discussed in Thread: SN65HVD1040-Q1 Hi Folks
My customer Alpine (China) is adopting SH65HVD1040-Q1 in their new project.
In their power system, the 5V supply has short power-down and recovery period of 49.6ms. After that, 5V supply is…
Other Parts Discussed in Thread: SN65HVD1040 I am trying to find a direct substitiue for Infineon TLE6251DS and the TI SN65HVD1040 looks like it will work. Can anyone confirm if these parts are interchangeable?
Part Number: TCAN1042H Other Parts Discussed in Thread: SN65HVD1040 HI Sir
I would like to use TCAN1042 to replace TJA1040 ,but TJA1040 pin5 is the same with SN65HVD1040 and have SPLIT pin
May I know what's condition have to use SPLIT pin ? or in…
Good controlled impedance cabling – Yes
Proper termination at both ends of cable
At TM4C123 end there exists proper termination with 120 ohm resistor, while at the other end it should be, as I am using http://www.peak-system.com/PCAN-USB.199.0.html…
