Part Number: SN74AHC138-Q1 Tool/software: Hi Team,
As we are performing the Functional safety analysis, we require few details related to one your part number ( SN74AHC138QWBQBRQ1 )
Failure modes
FIT rate
Failure distribution
Please provide…
Part Number: SN74AHC138 Other Parts Discussed in Thread: SN74HCS138 , SN74LV138A Hi Teams,
Do we have some new recommendations for SN74AHC138 with better cost and performance?
BRs,
Marsh
Part Number: SN74AHC138 Hello support team,
My customer need SN74AHC138 PSPICE simulation, but, this is not available on TI.com. Can we prepare it?
If not, they found that HSPICE model on TI.com, do you have any way to convert HSPICE to PSPICE model…
Part Number: SN74AHC138 Team, My customer is requesting us current consumption data under the following condition. Could you please support this? Vcc = 5.5V Ta = 25degC and -40~85degC Vin = Vcc - 2.1V Regards, Nobuhiko Wasa
Hi Robin,
Welcome to our e2e forum! I'm not specifically aware of anyone using four THS1207 devices in parallel like this, but there is no real reason why it would not work. Also, depending on your controller, you might consider using the THS1206 instead…
Hi Marco,
Can you verify that the ADS8558 is not in standby mode? Check the logic level of U3 pin 7, in the default setup, that pin should be low since the A/B/C inputs are pulled high. Adding a shunt jumper between the two pins on J4 DC_A0, DC_A1…
Hi Alessio, I apologize for my late response, I missed your feedback for some reasons.
Firstly, you will have to make sure your hardware connection and pin configurations are correct: 1. For software and serial mode, some pins will have to be pull up…
Other Parts Discussed in Thread: ADS8556 , SN74AHC138 , TMS320F28335 , TMDSDOCK28335 , TMS320LF2407A Hi all,
I am using an ADS8556EVM in the hardware mode . Lower 8 bits are not changing for any value of analog inputs. Iam using a single strand wire…
Other Parts Discussed in Thread: SN74AHC138 Hi,
How should I interface and communicate an alphanumeric LCD display with the DSK?
Also, From my understanding, the LCD pins are connected to that of the DSK via these points:
LCD pin number Name…
