Hello Lee,
Thanks for reaching out. Looking through our device families, we are not able to find a suitable device with a min/max prop delay difference of 1.62 ns
The device with the lowest prop delay difference is the SN74AVC1T45 .
Note: The…
Hi Stephen,
Thank you for your questions on this device. TI has more recently release the DS90LVRA2 receiver, which is a 1.8V dual channel device that may be a better fit for your application. Please refer to this application note: Level Shift No More…
Hello Jia,
1. Yes, the answer is the same as the previous thread. Trigger in 1 supply is the output reference voltage level. It will be either 3.3V or 1.8V depending upon your jumper selection
2. Unfortunately you cannot change the voltage level to…
Other Parts Discussed in Thread: SN74AVC1T45 , UCC27524 I have a board with four parallel strings of three IR LEDs (OSRAM SFH 4232), triggered at 1MHz for up to 33% duty cycle. A trigger comes into the board and goes 1. to a transceiver (SN74AVC1T45)…
If all you need is unidirectional translation for a single bit from 1.8V to 3.3V, then I would recommend looking into SN74AVC1T45. It can handle 1.8V to 3.3V translation up to 500 Mbps (typical).
Part Number: SN74AVC2T45 Other Parts Discussed in Thread: SN74AVCH1T45 , SN74AXC1T45 , SN74AVC2T245 , , SN74AVCH2T45 , SN74AVC1T45 Dear support community,
We recently started a new project on a protocol which has to have a certain accuracy at high…
Hello Rick, For interfacing between 3.3V LVTTL and 1.5V SSTL, the best option we have is the AVC family of translators. However, at 1.5V these translators will not support 200MHz. With a 3.3V output, the maximum frequency is going to be 160MHz for the…
