Other Parts Discussed in Thread: MOTOR-DRIVE-FET-LOSS-CALC , SYNC-BUCK-FET-LOSS-CALC We are using Office 365 (macros are activated) and when I klick on Start FET selection and then on 3c "Click Here FET1" nothing happens. Only the sheet is flashing and…
Part Number: CSD95379Q3M Hi Team,
We've been trying to use the SYNC-BUCK-FET-LOSS-CALC to calculate the losses of CSD95379Q3M.
It seems like every time I press any of the '--> --> CLICK HERE <-- <--' buttons a new selection windows starts to open but…
Part Number: SYNC-BUCK-FET-LOSS-CALC Other Parts Discussed in Thread: CSD19502Q5B Please advise how to add alternative MOSFET devices (would like to add the CSD19502Q5B for instance - it does not appear in the drop-down menu)
I only see about 20 available…
Hello Aaron
Thanks for the reply.
We are looking for a tool MOTOR-DRIVE-FET-LOSS-CALC for FOC . We have product which is running on DRV8353RS with trapezoidal control and currently planning to chnage to FOC. So we are trying to evaluate our current MOSFET…
Part Number: CSD88599Q5DC Other Parts Discussed in Thread: CSD88584Q5DC I discovered this spreadsheet recently and am trying to use it. I'm interested in the CSD88599 but it doesn't seem to give that as an option when I select FET Config, it only gives…
Part Number: SN65DP159 Other Parts Discussed in Thread: TDP142 , SN65DP141 We are looking at the SN65DP159 as an in-line DP to DP equalizer and we would like to monitor the PLL Control and Status Registers (address = 0x00) bit 7 "PLL_CLOCK" to identif…
Part Number: LM5143DESIGN-CALC Other Parts Discussed in Thread: LM5143-Q1 , LM5145 Hi team,
here is two confusing items of LM5143q design:
1.there is a descripton as following in the datasheet what seems not to make sense, actually it suppose that there…
Part Number: CC1310
Hello, I have a problem that with TI15.4 STACK, Beacon MODE, some times sensor will loss 4 beacons. But I checked the RSSI signal, it is good!
I route out LNA active pin to gpio. And I find that in sensor side, the beacon receive windown…
Part Number: LM5140ADESIGN-CALC Other Parts Discussed in Thread: LM5143-Q1 , LM5140-Q1 Hi Experts,
the LM5140ADESIGN-CALC seem to always recommend the same FET. Even when Vin is exceeding the max voltage of the IPC50N04. Is there an issue or is this part…