Part Number: TAS2505-Q1 Hi team,
When using the TAS2505-Q1, we observed during load short-circuit testing that a shorted load sometimes does not trigger the short-circuit protection.
The customer would like to know: What is the short-circuit impedance…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505A-Q1 , Hi TI comunity,
We are using TAS2505-Q1 on our products and searching on TI website we noticed that there is a new version TAS2505A-Q1. On the datasheet we didn't find no diferences…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: Hello,
For TAS2505-Q1, according to the information in the EvalKit PDF, when a short-to-GND condition occurs, it is not recommended to repeat the reset process more than…
Part Number: TAS2505-Q1 We have a sound playback device which outputs I2S signals (BCLK, DIN, WCLK, MCLK).
Now there are multiple I2S modes Left,right, dsp etc modes available in TAS2505-Q1. So, how to decide which configuration to use?
What should…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: In our hardware design for the automotive sector, we are using the TAS2505 Audio IC. During operation and in the short/open circuit mechanisms, there is no issue. However…
Part Number: TAS2505-Q1 Hello team,
The TAS2505-Q1 mounted on our board has stopped outputting sound at some point and continues to output a certain DC offset. Could you please tell us the possible cause of this problem?
The specific conditions…
Part Number: TAS2505-Q1 Tool/software: Hello TI,
Extend from this ticket, https://e2e.ti.com/support/audio-group/audio/f/audio-forum/1436383/tas2505-q1-am62x-external-amp-tas2505-output-signal-issue/5510319#5510319
We are preparing for Audio turning…
Part Number: TAS2505-Q1 Tool/software: HI!
I'd like to use pull-up resistor of TAS2505-Q1 SDA and SCL with 1.5 kΩ.
I could not find output low level current (IOL) of SDA and SCL in the data sheet. Is it possible to set 1.5 kΩ?
Please let me know…
Part Number: TAS2505-Q1 Tool/software: Hello TI
Our custom board connects to an external AMP (MCASP1 -> TAS2505->Speaker).
As far as we know, our arch is a Bridge mode and we expect to see the output of SPKP/SPKM wave form pattern are opposit , we…
