Part Number: TAS5411-Q1 Our product uses an I2C connection to the TAS5411. When a register read fails, it re-initializes the I2C connection and wants to reset the TAS5411. What suggestions do you have for the following parameters:
1. How long after…
Part Number: TAS5411-Q1 Hi team,
When testing the TAS5411-Q1, the customer found that 0x01 D7=1 when there was no sound. According to the datasheet, this should be an overtemperature shutdown, but the chip's displayed temperature was only 39℃. Why is…
Part Number: TAS5411-Q1 Other Parts Discussed in Thread: TAC5412-Q1 1. For the emergency call parts in GB 45672-2025 or GB 45314-2025, are there any audio solution designs (codec, amplifier) that can meet the requirements? If this is satisfied, the following…
Part Number: TAS5411-Q1 Other Parts Discussed in Thread: TAS5431-Q1 , Tool/software: Hi TI team,
Regarding issue https://e2e.ti.com/support/audio-group/audio/f/audio-forum/1370807/tas5411-q1-tas5411-q1-pvdd-voltage-drop/5240511#5240511, I still have…
Part Number: TAS5411-Q1 Tool/software: Hi Team Sir,
We'd like to inquire about the readability of the resistance value measured internally within the chip to diagnose open or short circuit conditions.
Thank you so much.
Part Number: TAS5411-Q1 Tool/software: Hello Expert,
May I ask will the open circuit load diagnostic be self cleaning?
I put way the speaker and read a open circuit diagnostic status through I2C 0x02 register. However when I plug the speak into OUTP&OUTN…
Part Number: TAS5411-Q1 Tool/software: Hi team,
We now want to confirm whether the PVDD power supply design of TAS5411 meets the requirements.
our speaker spec and power requirement：
speaker rated power: 2W
Speaker max power: 7.5W
Speaker…
Part Number: TAS5411-Q1 Tool/software: Hi supporter,
When I reset TAS5411 by set the STANDBY pin to 1->0->1, how long shall I wait before I can read the "Status and Load Diagnostic Register (0x02) after I reset TAS5411"?
Thanks
Part Number: TAS5411-Q1
1 Is it possible to write 0xBF to the address 0x03? When writing the value of 0xBF to the actual prototype, some prototypes make sounds while some don't.
2 In addition, how is the setting of the 0x03 register defined? Are the…
