Part Number: TAS5624A Tool/software: On the datasheet of TAS5624A, page 14. section "Start-Up and Shutdown Ramp Sequence". These is a specific requirement on the behaviours of the "Noise Shaper" with respect to the start-up and shutdown sequence…
Part Number: TAS5624A Other Parts Discussed in Thread: TAS5624 , Hello:
We plan to use the PBTL mode of TAS5624, but during testing, we found that when pin 21 (M) is set to high, the input current for this pin reaches 700mA. This exceeds the power supply…
Part Number: TAS5624A Hi,
I see that the TAS5624A Overcurrent limit protection typical value is 15A; is there a way to reduce the Overcurrent limit. My design needs overcurrent protection for a couple of amps.
Regards,
Mustafa
Hello!
Does the TAS5828MEVM support USB audio asynchronous transmission mode? If it does, how can it be configured? We have connected the TAS5828MEVM to a PC and have installed the official TI USB Audio 2.0 V0.71 driver. During use, we detected that there…
Part Number: TAS5558 TAS3251 TAS5624A Other Parts Discussed in Thread: TAS5624A , TAS3251 For development of a speaker with integrated power amplifier and DSP capabilities we found 2 solutions by TI as interessting:
- TAS5558+TAS5624A - TAS3251 Our requirements…
Part Number: TAS5624A Other Parts Discussed in Thread: TAS5634 Hi,
My current Amplifier configuration is TAS5534 + TAS5634 (2xSE + 1BTL). For the SE channel, the power output at 10% THD not able to reach 110W (around 106W).
can the modulation index helps…
Part Number: TAS5624A
Hi experts,
My customer wants to use different PVDD source for PVDD_AB and PVDD_CD on TAS5624A.
They will adopt two different power source which is almost same voltage as attached picture.
Are there any concerns for this connection…
Part Number: TAS5624A Other Parts Discussed in Thread: TAS5558 Hi,
If I want to get same signal(PWM_A/B) amlifaction for both out_A/B and out_C/D, just need to connect PWM_C/D to ground. Is this correct?
Thanks
David
Part Number: TAS5624A Other Parts Discussed in Thread: TAS5624 HI TI,
Regarding TAS5624 PVDD idle current , in datasheet stated is 15mA for one full bridge.
However I check TAS5624EVM , actual measurement result is about 25mA for one full bridge.
May…
Part Number: TAS5624A Hi,
We are looking into developing a new product using the TAS5624a class D amplifier, and wanted to know what the End Of Life is for the TAS5624A? Regards,
Mustafa