Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TAS5760M-Q1 Other Parts Discussed in Thread: TAS5720A-Q1 Tool/software: Hi team,
Would like to have a quick check with you. Previously, customer used both OUTA and OUTB channel. But there have some requirement change which only require one…
Part Number: TAS5760M-Q1 Other Parts Discussed in Thread: TAS6422-Q1 Tool/software: Hi team,
Customer met some problems that there is a probabilistic communication failure on I2C configuration for bothTAS5760M-Q1 and TAS6422-Q1.
Below is the startup procedure…
Part Number: TAS5760M-Q1 Tool/software: I need to distinguish if the onboard amplifier is the TAS5720 or the TAS5760. Is it possible to distinguish the TAS5720 from the TAS5760 via I2C? The "Device Identification" register value is 0x00 for both devices…
Part Number: TAS5760M-Q1 Hi All,
I'm currently working with a Linux-based device on an ARM architecture, specifically running kernel version 5.15.71 . I'm looking to interface an Audio amplifier with part number TAS5760M-Q1 to this device. Could…
Part Number: TAS5760M-Q1 Tool/software: Hello,
I am working on TAS5760M-Q1.
At the power up, I set the following registers :
REG ADDRESS
DATA
0x02
0x04
0x01
0xFD
0x06
0x51
The others are kept as default.
The master and I2S clocks are set…
Part Number: TAS5760M
Team, Can we please help with the belwo question:
We use the amplifier in BTL (stereo) mode (In case needed I can share the TAS5760 portion of the schematic off-line if needed). However we now need to drive a speaker with less than…
Shadow He said: It's glade we find out the problem. I'm just curious that do you mean the Hold time at START condition, 0.6us? From the waveform, the time seems enough, maybe the SDA shouldn't goes up before SCL pulled low, it's a good catch.…
Part Number: TAS5760M-Q1 Hi TI team,
We have requirement for class D audio amplifier for automotive application.
It should driver x2 5W, 8 ohm speakers.
Audio type Stereo.
Also, it should support load diagnostics
TAS5760MTDAPQ1 , meets above first 2…
Part Number: TAS5760M Hi team
I have a question about power consumption.
The conditions of use are as follows.
【conditions】 PVDD: 24V Rspk: 8Ω SPEAKER AMPLIFIER STATE: fspk_AMP =768kHz,Shutdown
【question】 ①The following values listed in the data…
Part Number: TAS5760MD In the TAS5760MDAPR audio amplifier datasheet, the "DAP 32" pin package (TSSOP) shows two different suggested footprint drawings with different dimensions. This is very confusing. There is no clear indication of which…
