Part Number: TAS5822MEVM Tool/software: Hello,
we have the TAS5822MEVM and we are trying to configure and control it with a custom microcontroller.
The two audio amplifier on the boad are configured in "mono" (PBTL mode). The I2C bus from the microcontroller…
Part Number: TAS5822MEVM Other Parts Discussed in Thread: TAS5822M , Tool/software: Hello,
We are designing a device where we use the class-D audio amplifier TAS5822M to drive a speaker of 8ohms. The audio amplifier is configured by a microcontroller…
Part Number: TAS5822MEVM Other Parts Discussed in Thread: TAS5822M I had a problem tuning the TAS5822MEVM: I controlled the I2C of my power amplifier TAS5822M for tuning through the I2C of TAS5822MEVM. I adjusted the EQ and related parameters and saved…
Part Number: TAS5822MEVM Other Parts Discussed in Thread: TPA3220EVM , TAS5822M Tool/software: Dear expert,
Could you help on below technical issue? The test is based on TAS5822MEVM
Test conditions: PVDD = 24V, speaker load: 4Ω@PBTL mode, music name…
Part Number: TAS5822MEVM Hi Team,
My customer is facing some issue regarding TAS5822EVM.
If they change the eq/Drc or change the input level instantly, TAS 5822 will be protected, speaker out and Sdout no signal.
Configuration 2.1.
Do you…
Part Number: TAS5822MEVM Other Parts Discussed in Thread: TAS5822M Tool/software:
hello
Attached is the file of our software engineer, burned to our audio firmware test, we found that there was no sound when adjusting the power amplifier of the treble…
Part Number: TAS5822MEVM Other Parts Discussed in Thread: TAS5822M Hi Team,
When using the power supply to test the EVM, the power supply will be over-current protection,
Measure the impedance of J9(PVDD) and J10(GND) with a multimeter, it is close…
Part Number: TAS5822MEVM Hi
I own the TAS5822MEVM and I had requested the PPC GUI plugin access weeks ago to be added to my account and I still have not received the SW access when I log in with PPC 3.x
Part Number: TAS5822MEVM Other Parts Discussed in Thread: TAS5825M TAS5822MEVM, PPC3 default configuration, BTL mode, 8ohm ,PVDD=24V, can get 2*35W/1% output as datasheet description, the actual test result is about 33W.
