Part Number: TCAN332EVM Other Parts Discussed in Thread: TCAN332 , SN65HVD1050 Hi,team.
I want to operate TCAN332EVM with split termination and nomal mode. i have 3 question.
①How should I set JMP 6?
②I think , I can operate split temination…
Part Number: TCAN332EVM Other Parts Discussed in Thread: TCAN334 , We are considering using TCAN334. The circuit diagram of TCAN332EVM is used as a reference.
question 1: Are there any recommended products for L1 and D2? Please tell me the…
Part Number: TCAN330 Other Parts Discussed in Thread: TCAN332EVM Hi.
A question about the Test Points in CANH & CANL in TCAN330 EVM board.
The board has TPs directly connected to the CAN signals and other TPs connected to the signals through a resistor…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62 , TCAN332EVM , TCAN332 Hello,
I connected the SK-AM62 board to a TCAN332EVM board.
The PIN CAN_RX/TX (8/10) from the user expansion connector are connected to RX/TX pin of the TCAN332EVM…
Hi Carlo,
Sorry, we don't have a C2000 EVM that has more than one CAN transceiver. I can think of a couple options you could try below:
Wire CAN signals (and Ground) to a 2nd C2000 LaunchPad CAN transceiver pins. LAUNCHXL-F280049C would probably…
Hi Harrison,
There is a reference schematic in the EVM User's Guide. You can find it here:
www.ti.com/.../sllu231.pdf
The folder for the EVM board is here:
www.ti.com/.../tcan332evm
Let me know if you need anything else.
Best regards…
Nenad,
You used the phrase “full functionality” for CAN. The ControlCARD+Docking station eco-system does not have CAN transceivers. Sure, you can run the loopback test. However, for you get the “true feel” of the CAN bus, you need to run some tests…
