Part Number: TDES960 Hi Support Team,
In the data sheet, in section 7.4.19 CSI-2 Transmit Frequency,
it says 1.2 Gbps (not available on prototype), does this mean that 1.2 Gbps is not available?
Best regards,
Part Number: TDES960 Hello,
My customer wants to use INTB with 3.3V pull-up and I2C with 1.8V pull-up.
The datasheet recommends to set the IO voltage at I2C voltage which is 1.8V.
If IO voltage is set at 1.8V, is it acceptable to put 3.3V pull…
Part Number: TDES960 Hi All,
I have aquestion about TDES960.
The datasheet shows the back channel output waveform (Figure 6-12.).Is it possible to measure this? If it is possible, please tell me how.
Best Regards, Ishiwata
Part Number: TDES960 Hi Support Team
According to 7.4.19 CSI-2 Transmitter Frequency, it is stated that the CSI-2 timing parameters are automatically set when CSI-2 TX Data Rate=800Mbps and 1.6Gbps are set. I believe that the CSI-2 timing parameters…
Part Number: TDES960 Other Parts Discussed in Thread: TDES954 , , TSER953 I'm designing a surround view system based on TSER953 serializers in camera board and TDES960 and TDES954 deserializers in processor board for up to six cameras through two MIPI…
Part Number: TDES960 Other Parts Discussed in Thread: TDES954 , , TSER953 We are planning a surround view system based on TSER953 serializers in camera board and TDES960 and TDES954 in processor board for up to six cameras through two MIPI CSI-2 ports…
Part Number: TDES960 Other Parts Discussed in Thread: TSER953 , Hello,
We have a MIPI camera system with the TDES960 and the TSER953. We cannot achieve a back channel frequency of 50MHz.
Our REFCLK for the TDES960 is 25MHz.
The MODE pin on the TDES960…
Part Number: TDES960
Hello,
I'm trying to programm TDES960 I2C register from I2C_SCL pin12 and I2C_SDA pin11 pulled by 3.7K to VCC (3.3V).
The PDB pin is pulled to 3.3V by 10K with 10µF capacitor as suggest in 9.2.1.
My problem is I cannot obtain…
Part Number: TDES960 Hi team,
My customer wants to design in TDES960 and have a question.
When I/O as 3.3V, PDB(RESET) PU High Voltage can be use as 3.3V or GPIO control?
Part Number: DS90UB960-Q1 Other Parts Discussed in Thread: TDES960 Hi
The customer has a new project that can only provide one set of MIPI (CLKP/N+CSI0~3P/N),
but it needs to be connected to two devices: CAMERA (8M) and barcode. Is there any difference…
