Search tips
Showing 145 results View by: Thread Post Sort by
    Answered

  • THP210: THP210 Open-Loop Output Impedance

    Resolved
    Part Number: THP210 Hi Support, I would like to know if I should read the Output Impedance plot as Differential Output Impedance plot? Because at the table spec section, the Zout is spec'd at 14ohm at 100kHz, but the curve reads roughly 8ohm.…
    • Resolved
    • Answered

  • THP210: Difference between THP210 & OPA1637?

    Resolved
    Part Number: THP210 Other Parts Discussed in Thread: OPA1637 , OPA1632 , OPA205 , OPA206 I'm looking for an FDA for a couple applications. The THP210 or the OPA1637 looks promising at first glance. A few questions regarding what I've noticed so far: …
    • Resolved
    • Answered

  • THP210: LM35 and THP210 Combination

    Resolved
    Part Number: THP210 Other Parts Discussed in Thread: LM35 Tool/software: Hi All, I have inherited a set-up for reading ambient temperature that goes as follows: LM35--> THP210 (gain 0f 1)--->Differential ADC. For values of components please see the attached…
    • Resolved

  • THP210: THP210 MFB filter simulation

    TI Thinks Resolved
    Part Number: THP210 Tool/software: TI TINA Hi, I am trying to simulate the circuit shown in section "9.2.1 MFB Filter" of the THP210 datasheet. I changed the voltage sources so that the THP210 has a single supply of 3.3V and the common mode voltage…

  • THP210: THP210 Malfunctions at Low Temperatures

    TI Thinks Resolved
    Part Number: THP210 Tool/software: Hi, I had previously been discussing the THP210 with Luis Chioye via private messages. However, as Luis is no longer handling this product, I am reaching out in a new thread to continue the discussion. Our customer…
    • Answered

  • THP210: Connect THP210 diffrencial output with a long twisted pair cable to 12 Bits SAR ADC input

    Resolved
    Part Number: THP210 Other Parts Discussed in Thread: OPA1637 Tool/software: Hello, I must connect the diffrential output of a THP210 op amp which has 30 mA output capability and enough bandwith over a long twisted pair cable AWG 22 to a 12 Bit SAR ADC…
    • Resolved
    • Answered

  • ADS127L11: ADS127L11+THP210+REF6041 bipolar PowerSupply (Schematic Review)

    Resolved
    Part Number: ADS127L11 Other Parts Discussed in Thread: REF6041 , THP210 , Hello, I would like to ask for support or a schematic review for the bipolar power supply of the ADS127L11+REF6041 and THP210. I have a single-ended AC-coupled signal…
    • Resolved
    • Answered

  • THP210: Geophone amplifier

    Resolved
    Part Number: THP210 Tool/software: Hello Raymond, Thank you for suggesting the circuit. Could you please share the transient analysis screenshot, here I have not good results. Please check that there will be 54 Ohm feedback resistor from first stage…
    • Resolved
    • Answered

  • THP210: Single supply design

    Resolved
    Part Number: THP210 Other Parts Discussed in Thread: ADS127L14 , ADS1288 Tool/software: Hello Luis, Thank you again for your support. We have tested ADXL354 MEMS accelerometer, it worked well. Now we are stepping to production. We will have two…
    • Resolved
    • Answered

  • THP210: Behavior when PD = VS– in Dual Supply Mode

    Resolved
    Part Number: THP210 Other Parts Discussed in Thread: THS4130 Tool/software: Hello, I am working on designing a circuit that is compatible with both the THS4130 and THP210. We will decide which IC to use based on the results of lab testing. However…
    • Resolved

Didn't find what you are looking for? Post a new question.