Part Number: THS3470REBEVM Hi,
Is it possible to configure the board to have 20x amplification (instead of the default 5x) using a 2000 ohm feedback resistor and a 105 ohm gain resistor? In the user manuel (THS3470REBEVM Schematic), two 4200 ohm resistors…
Part Number: THS3470REBEVM Tool/software: Hi
Where can we can buy a THS3470REBEVM eval board ? The TI website indicates that this electronic card can no longer be purchased ?
Regards
Part Number: THS3470REBEVM For this EVM, the 50 ohm load resistors are spec'd at 0603, 0.1 W.
For a CW signal, this suggests that the maximum input voltage should be about 2.2 V, yet you suggest a DC measurement of 4 V, which will cause the resistor…
Part Number: THS3470REBEVM Other Parts Discussed in Thread: THS3470 Tool/software: Hi Support Team,
The documentation of THS3470 describes a power down mode controlled by P0 and P1 pin (No. 30 and 31). If both pins are connected to ground the power…
Part Number: THS3470 Tool/software: To the TI team:
We have purchased several of your THS3470REBEVM boards. We have the following questions:
1). When will the THS3470 part be finally released in production silicon and be able to be purchased? We have…
