Part Number: THS3491RGTEVM Other Parts Discussed in Thread: THS3491 Hi Ignacio,
I am in the process of evaluating thermal design for THS3491, and would like to know the temperature rise at the top of package for the op amp on THS3491RGTEVM under the…
Part Number: THS3491RGTEVM Other Parts Discussed in Thread: THS3491
Hello Experts,
According to datasheet on page 4 (2.2) :
Desoldering the output matching resistor and replacing it with a single 50-Ω series output resistor that gives only 6-dB…
Part Number: THS3491RGTEVM Other Parts Discussed in Thread: THS3491 , THS3091 Tool/software: Hi, So I needed a buffer at 100MHz 200MHz and 300MHz which can give output voltage 20, 15, 10 respectively at those frequencies. THS3491 seems like the best fit…
Part Number: THS3491RGTEVM Other Parts Discussed in Thread: THS3491 HI TI forum,
I recently used this evaluation board to measure the frequency response of THS3491RGT when in A = 10V/V, using a range of Rf and Rg (feedback / gain resistors).
I used…
Hi Ahbib,
please show your latest schematic. And please post a photo which shows your modifications carried out on the EVM board.
Maybe you have damaged the OPAmp during experimenting? Then check again with a fresh one :-)
Kai
Part Number: THS3491RGTEVM Other Parts Discussed in Thread: THS3217 , THS3491
Hell there,
I have a THS3491RGTEVM and want to use it to amplify 20-40M square wave to 10Vpp (with input up to 1Vpp). I can get the waveform amplified to 10Vpp with a…
Part Number: THS4303 Other Parts Discussed in Thread: THS3491RGTEVM , THS3491 Hi Team,
I would like to request please, if possible, to receive the gerber files for the following evaluation boards:
THS4303EVM
THS3491RGTEVM
Also, if you know of…
Hi Stefan,
have you read section 2.2 of the EVM manual?
www.ti.com/.../ths3491rgtevm
Maybe the resistors of the output resistor network have some manufacturing tolerances? For a small signal response measurement you could replace the output…
