Part Number: THS4032 Other Parts Discussed in Thread: THS3115 , OPA2690 , OPA690 , OPA2889 , OPA2890 , OPA2625 Hi Team,
We would like to request your help regarding the customer's inquiry below.
I am looking op-amp similar to ths4032 but with enable bit…
Part Number: THS4032 Hi Team, I am using THS4032 as a trans-impedance amplifier in one of my applications. My input signal is a 250kHz, +/-10V signal. How to calculate the slew rate and gain-bandwidth product required for the op-amp for such a signal. Actually…
Part Number: THS4032 Other Parts Discussed in Thread: OPA837 , LM7705 Hi, I am checking if it is possible to share 1 OP-AMP (THS4032) to multiple ADC input as in picture, or if there is solution to share 1 op-amp to multiple ADC (I have device with multiple…
Hi Ishan,
Our tool cross reference tool suggests the THS4032 as a potential replacement for the LT device, however the minimum supply requirement is 9V. In simulation, the device does not suggest any potential failure points and certainly does not show…
Part Number: THS4032 Other Parts Discussed in Thread: OPA564 , , OPA2210 Hi there,
We have this step motor drive board which need to be cost down. the signal chain is as below.
DAC7811----> THS4032 (signal conditoning stages) x2-----> OPA564 (howland…
Part Number: THS4032-EP Is there a recommended configuration for connections on an unused channel with this device. For example, should they all be grounded or left as no connects. Any insight on this would be much appreciated.
Part Number: THS4032 Other Parts Discussed in Thread: LMH6559 Hi, I am currently using THS4032 to design my ADC input circuit. the problem is i only have limited source (ATE tester resource) but multiple test site required. what is the maximum number…
Hi Mohd,
Apologies for the delay. With the input floating, then the THS4032 will probably rail to either supply. This will cause a problem when the output voltage is different from V3, as the two voltages will compete and potentially cause sufficient…