Part Number: THS4151 Other Parts Discussed in Thread: THS2630 , THS4131 , THS4130 , THS4150 , THS7001 Tool/software: We're planning on using a THS4151 in a new design, but are a bit worried since it is an older part. The THS2630 is listed as a drop-in…
Part Number: THS4151 Other Parts Discussed in Thread: THS4551 , THS4505 Tool/software: Dear Specialists,
My customer is considering THS4151 and has a confirmation request.
I would be grateful if you could advise.
---
When ±2V is input to VIN_P…
Part Number: THS4151 Hi,
The data sheet states that when Icc Vcc=±15V Ta=full range, MAX:23mA. Is this correct in that on the +15V power supply side, the maximum is 23mA/2 = 11.5mA, and on the -15V power supply side, the maximum is 23mA/2 = 11.5mA?…
Part Number: THS4151 Hi,
Is the calculation formula for the THS4151ID offset adjustment circuit correct?
■Output common mode voltage VOCM = (VOUT_P - VOUT_N) / 2
■Output differential voltage VOD = VOUT_P - VOUT_N
If R1 = R3 = Rg ,R2 = R4 = Rf…
Part Number: THS4151 Other Parts Discussed in Thread: OPA810 , THS4551
Hello all,
I have simulated the shown attenuator circuit on TINA. The purpose of the circuit is to drive an ADC. The input signal would be a sensor signal ranging from -10V to…
Dear sir,
Kindly provide the following details to use the gain and offset error excel calculator.
1. INL value for AMC1300B.
2. INL Drift value for the AMC1300B
3. Rdivider impednace ( Equivalent impedance (Ω) of the resistor divider) : Is…
Part Number: THS4151 Other Parts Discussed in Thread: ADS54J40 , THS4541 Hello,
I want to dc drive the ADS54j40 with THS4151 amp. (+/-5v supplies)
The input max signal is +/-3V and that should match the ADC max range input of 1.9V.
Attached is my…
Part Number: THS4151 Other Parts Discussed in Thread: AMC1300 , , THS4131 Dear sir,
We are using AMC1300 for current measurement.
Measurement range : 0 to 40Arms
Shunt resistance : 2mOhm
High side voltage input : 113.12mV peak
low side voltage…
Other Parts Discussed in Thread: THS4502 Hi, Im simulating the THS5151 with multisim (the spice model from TI) and have some questions.
Why the positive and negative output have differents offsets (image of the simulation attached)? Can someone help…
Other Parts Discussed in Thread: THS4151 Hi
I'm using THS4151 as a video differential driver. I use +-12V power supply.
CMV pin is used not to set reference voltage but to apply some ac signal.
CMV ac signal has 500kHz. but I found small portion…
