TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel


Search tips
Showing 19 results View by: Thread Post Sort by
  • THS4222: THS4222 Issue

    HD
    HD
    TI Thinks Resolved
    Part Number: THS4222 Other Parts Discussed in Thread: TLC074 , OPA2690 , OPA2890 Hi, I need support about a simple circuit involving THS4222. Attached you can see the circuit. The input signal is a sinewave 3Vp 50Hz (0 offset), the output signal…
    • over 1 year ago
    • Amplifiers
    • Amplifiers forum
  • Answered
  • THS4222: PowerPad connection when Dual Supply is used

    Andrea Ieri
    Andrea Ieri
    Resolved
    Part Number: THS4222 Good morning, in some of my circuits I've aready used your High Speed Dual OpAmp THS4222 in 8VSSOP package (THS4222DGK, Without PowerPad) and I'm very interested in continuing to use it. I need now to switch, for power dissipation…
    • Resolved
    • over 3 years ago
    • Amplifiers
    • Amplifiers forum
  • THS4222: Output's Rising time and delay time question during high temp condition

    Paul Yeh
    Paul Yeh
    Part Number: THS4222 Other Parts Discussed in Thread: OPA2830 , LMH6643 Hi team, My customer design THS4222 as OP amplifier design but they found this OP output rising time and delay time will change in high temperature condition. please look at my…
    • over 2 years ago
    • Amplifiers
    • Amplifiers forum
  • Answered
  • RE: THS4222: THS4222 as a buffer, simulate using TINA

    kai klaas69
    kai klaas69
    Resolved
    Hi Senthilnathan, if you take a look at figure 17 of datasheet, you will notice that the THS4222 has an open loop gain of only 10dB at 40MHz. So, with a closed loop gain of 0dB you have only a loop gain of 10dB, which is not enough to make the OPAmp…
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • RE: TINA/Spice/THS4222: Gain/Phase response of open loop

    Herman Theodorus
    Herman Theodorus
    Hi Senthilnathan, I think your plot above is going in the direction. Extend your frequency sweep beyond 80MHz.. extend it to 1GHz and you will see f0dB around 133Mhz and Phase Margin from simulation around 55 degree. Herman
    • over 7 years ago
    • Simulation, hardware & system design tools
    • Simulation, hardware & system design tools forum
  • RE: THS4222: High failure, chip not working

    Rohit Bhat
    Rohit Bhat
    Hi Mateusz, Please send the full design file so that I can look over. Best Regards, Rohit
    • over 8 years ago
    • Amplifiers
    • Amplifiers forum
  • Answered
  • THS4222: Maximum quiescent current

    Gerald Sellmair
    Gerald Sellmair
    Resolved
    Other Parts Discussed in Thread: THS4222 Hi TI community, sorry to bother you with a most probably stupid question, but I am a bit confused now. I am using the THS4222 with a +/-5V supply. Looking at the measured quiescent current I can see approx…
    • Resolved
    • over 12 years ago
    • Amplifiers
    • Amplifiers forum
  • THS4222 gain performance.

    swapna bramandlapally1
    swapna bramandlapally1
    Other Parts Discussed in Thread: THS4222 , OPA2690 , OPA2691 Hi TI technical Support, Please find the figure below. Here i am confusing with first parameter. In small signal bandwidth: test conditions it is showing that G=1,Pin = -7dBm. what is…
    • over 12 years ago
    • Amplifiers
    • Amplifiers forum
  • SN10502: About current consumption specifications

    Tsukui Yusuke
    Tsukui Yusuke
    Part Number: SN10502 Other Parts Discussed in Thread: TINA-TI , THS4222 , OPA2830 , OPA2836 Hi, My customers are considering the following circuits. SN10502.pdf When evaluated with an actual machine, it was found that the heat generation was large. I…
    • over 4 years ago
    • Amplifiers
    • Amplifiers forum
  • Answered
  • RE: AD828 vs 826 EMG

    LeonardEllis
    LeonardEllis
    Resolved
    Hello Mike, You state the AD828 in the SUBJ and the AD A 828 in the text, and both of these are Analog Device parts, therefore, we cannot comment on the usage. If you wish to do a design with a similar/better TI device, please look at the THS4222 or…
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
>

Didn't find what you are looking for? Post a new question.

  • Ask a new question