Part Number: THS4303 I am looking to use this amplifier for positive signals only i.e 0 to 0.2V. However, during simulation, the amplifier only works if powered from split rail supply.
Is this the expected way of operation? And if I use single power…
Part Number: THS4303THS4303 is used in ADS to compare the effect of loading the recommended decoupling circuit and not loading the decoupling circuit：
For my design, the effect is better without adding decoupling circuit, but the effect is very poor…
Part Number: THS4303 I have some questions concerning using several THS4303 amplifiers in cascade:
1) In the datasheet, a shunt 49.9 ohm resistor is used at the input and a series 49.9 ohm resistor is used at the output for matching. If I were to…
Part Number: THS4303 Other Parts Discussed in Thread: TINA-TI hi there,
I am rahul vishwakarma i have bought this IC 4303 for the application of Negative impedance converter.The simulation part is done and i am getting result. The problem arises when…
Part Number: THS4303 Other Parts Discussed in Thread: THS4304 Does TI have S-parameter data for the THS4303 up to higher frequencies like 10 GHz?
Thanks,
Jonathan
Hi Hamza,
your layout should look much more like the recommended layout shown at page 21 of datasheet. So, you need much more ground fill in the middle of your board. The THS4303 must be fully embedded in the ground plane of top layer, like shown in…
Hi Mete,
Thank you for the follow-up! I will also look into any board delay and also clarify some of the measurement decisions. I'll get back to you soon.
Best,
Alec
