Part Number: THS4505 Other Parts Discussed in Thread: THS4509 I designed Band Pass Filter using THS4505 Fully Differential Amplifier . The simulation in TINA gives gain vs frequency plot as per R,C values selected for the band. But when same design is…
Part Number: THS4505 Hello,
A customer asked what is the ESD rating of the THS4505DR?
It's qualification report refers to the data sheet, but I didn’t find ESD class definition there.
Thanks.
Part Number: THS4505 Other Parts Discussed in Thread: THS4504 , THS4551 , THS4561 , In accordance with the data sheet the common-mode input range of THS4504/4505 at Vs=5V (single supply) is from -0.1 to 2V over temperature (see page 7 of the data sheet).…
Part Number: THS4505 Hi, Good day. Our customer is using the THS4505. In the data sheet, DGN0008D and DGN0008G Package outline is given. Which package outline is applicable for the part THS4505DGN Thank you. Regards, Cedrick
Part Number: THS4505 Other Parts Discussed in Thread: THS4561 , THS4551 Hi Team,
Can you please help with ADA4945-1 functional equivalent.
Regards, Shinu Mathew
Part Number: THS4509 Other Parts Discussed in Thread: THS4505 , THS4504 The circuit is as follows:
codec giving differential output of 800 mVrms, then THS4509 for amplification and impedance matching. Resistance connected between THS4509 and codec is 100…
I am attempting to simulate a circuit in TINA with gain of 10 using the resistor values suggested on page 21 of the datasheet. However, both these resistors and the resistors in the equations are labeled with numbers while the corresponding figures are…
Other Parts Discussed in Thread: THS4505 , TINA-TI , LMH6551 Hello,
Our customer would like to use THS4505 for below conditions.
Are there any application note or refference design for below conditions ?
-Input : Single End, 1Vpp, 10.7MHz
-Output: Differential…
Hello Pratik,
We do not have FPGA example code for the ADS8900B ADC. However, you can use a standard SPI-00-S interface to the device for initial development, and then change to quad-SDO if you need to lower the SCLK frequency. Details are in section…