Part Number: THS4531A Other Parts Discussed in Thread: TIDA-00187 , OPA837 , OPA835 , OPA838 , OPA2810 Hi,
My customer is interested in TIDA-00187 true zero volt output amp. They are asking:
Is there also a single ended version? We don’t use too many…
Part Number: THS4531A Other Parts Discussed in Thread: ADC122S655 , , TINA-TI I am looking to use THS4531A as differential amplifier driving ADC122S655. The source is a high voltage sensor. I have the sensor pins connected through resistor divider to…
Other Parts Discussed in Thread: THS4531A , TIDA-00522 Inside the datasheet of the THS4531A (revision January 2016), there are a section Layout (chapter 11 / page 45).
Inside this section, on the item 3, it is possible to read : "Ground or power planes…
Part Number: THS4531A Other Parts Discussed in Thread: THS4531 Dear Specialists,
My customer is considering THS4531 and has a question.
Could you please advise?
---
According to the datadheet, it is described gain is less than 10.
Is it possible…
Hi Loren,
Thank you for offering to look at the devices.
I have arranged for the THS4531A chip used on CH35 of my initial post to be removed from the circuit board and be shipped to TI. This may take a day or two since it is beyond my skill set…
Other Parts Discussed in Thread: THS4531 , THS4531A , THS4524 , THS4522 , THS4521 I think there are errors in the spice models for the THS4531, the THS4531A and TH4532.
The THS4531.TSC example (in EXAMPLES\TI Test Circuits) yields an operating current…
Other Parts Discussed in Thread: THS4531A I require the THS4531A to have a low noise output at DC. The datasheet suggests using a 220nF capacitor on the Vocm pin to reduce noise.
I tried a simulation in TINA using a unity gain configuration (4.7kilohm…
Part Number: TLV9042 Other Parts Discussed in Thread: ADS8881 , , THS4531A Hi,
I'm designing a battery operated acquisition system with an FDA in front of ADS8881 SAR and since I need a 10 MEG input impedance I was thinking to use TLV9042 as a unity…
Part Number: ADS7863A Other Parts Discussed in Thread: THS4531A , ADS7863 ADS7863Aを使用して、ADCを使う場合、ADC入力信号が小さい場合に前段で差動AMPを使用します。 ADS7863Aのアナログ側は5V、デジタル側を3.3Vで使用します。 THS4531AのAMPの電源は5Vで、中点は2.5Vです。
質問1 THS4531Aの差動AMPを使用しますが、そのTHS4531AのCOM端子が入力の基準になるため、…
