Part Number: THS4601 Other Parts Discussed in Thread: OPA818 , THS4631 , THS4211 We use the THS4601 in a design the same as the application described on the datasheet for a 100KR transimpedance amplifier, The bandwidth of this device is only 10MhZ, I would…
Part Number: THS4601 Other Parts Discussed in Thread: OPA810 We use the THS4601 as part of a photodiode design, this is a few years old, and was enquiring if there are any other new TI parts that have a better bandwidth or noise performance similar to…
Part Number: THS4601 Other Parts Discussed in Thread: OPA838 , OPA810 ,
Hello team.
I'm unable to make a decision.
Do I need to insert resistor(3pin-GND) for canseling bias current(2pin) about curcuit to detect photodiode current(likes fig26) ?
If I need…
Part Number: THS4601 Hi Team,
Customer has a quick question regarding to THS4601 datasheet spec.
Customer wants to know if their system ambient can go to 80C.
To determine total input offset voltage, should they refer to 5mV(-40~85C) directly, or 4mV…
Part Number: THS4601 Other Parts Discussed in Thread: OPA657 , LM6172 A circuit calls for a THS4601 which is surface mount. Does this come in 8DIP. Thank you.
Other Parts Discussed in Thread: OPA1641 , OPA827 , LME49860 , THS4601 Hi,
I have seen in one post about minimum GBW for a filter, right now I have an audio filter project base on state variable filter using LME49860 & OPA1641 or OPA827 with:
F: 665Hz…
Hi Karl,
the THS4601 and the THS4631 discuss the "overdrive recovery" in their datasheets.
I would give the input low pass filter a try. And I would modify the input signal in order to prevent the output of OPAmp from clipping. Then you even…
Hi Kai
Thanks for your advice. Reading the thread you pointed out I understand that the only alternative is THS4601 as we need to use supplies over +-6V. The problem with THS4601 is the 10pF input capacitance which is too high for our application.
Is there…
Part Number: THS4631 Other Parts Discussed in Thread: THS4601 Hi,
A customer of mine would like to know the maximum differential input voltage of the THS4631D. They cannot find it in the datasheet. Can you specify this for them please?
Thank you!
Hello Ricardo,
There are no current sensing amplifiers with bandwidth to support 15 MHz. You might want to look through for high-common mode voltage transimpedance amplifiers, such as the THS4601 that can support your high-side configuration with 12V…
![[FAE] Andrew Wang](https://e2e.ti.com:443/cfs-filesystemfile/__key/communityserver-components-imagefileviewer/communityserver-components-avatars-00-00-07-45-83/4TN3ECJKFL7N.jpg_2D00_24x24x2.jpg?_=638280151088694360)
