Part Number: THS4631 Other Parts Discussed in Thread: THS3091 , , TINA-TI
Tool/software:
Hi,
We are working on a High Voltage Signal Conditioner project. We are planning to use THS4631 and THS3091 OpAmps in the design.
We are looking for Unencrypted Spice…
Part Number: THS4631DGNEVM Other Parts Discussed in Thread: THS4631 Tool/software: Hello, I am Yeahia. I would like to get some help THS4631, would you mind connecting to me an Engineer?
Hi Luke, and thank you for your response. Actually, the question is about the MOSFET. I need advice on the correct MOSFET for this application, controllable via a 3.3V microcontroller. Also, I’m still waiting for answers to all the other questions, especially…
Part Number: THS4631 Tool/software: Hello,
I can see in the previous threads that this question has been asked before, but the answer has been sent by mail to the requester.
So I ask again : on the THS4631, are they some protection diodes on inputs…
Part Number: THS4631 Tool/software: Hi,
I am using the THS4631 in a high-voltage differential measurement probe where I need to measure an analog signal with a frequency up to 50MHz. A 49.9-ohm resistor is connected between the op-amp's output and the…
Part Number: THS4631 a. Is there a protective diode built in between the input terminals of the THS4631?
b. If it is built in, can you tell me the current-voltage characteristic and the conditions under which it is used?
For example, as follows,
…
Part Number: THS4631
Dear Experts,
I have assembled the peak detector circuit using THS4631 as shown below. https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/940064/how-to-improve-the-accuracy-of-peak-detector-as-high-as-posssible#pi320995…
Part Number: THS4631 Other Parts Discussed in Thread: OPA656 , OPA810
My question is, does TI have a curve or data shown the input current noise density as a function of frequency for frequencies above 10 kHz, extending up into about 1 MHz?
For some background…
Part Number: THS4631 Other Parts Discussed in Thread: THS3491 , , OPA548
Hello!
I always thanks for your great supports.
Back in the last thread, I solved problem to reduce the cable and improve Rf 30 to 800ohm. (Thanks Kai )
But unfortunately, I can't…
