Part Number: THS6012 This part was purchased from Digikey but the logo and lettering look very different from the last batch. The logo is sloppy looking and the lettering sits on the chip crooked.
Part Number: TPA6120A2 Other Parts Discussed in Thread: THS6012 I was looking at some of the subtleties of the TPA6120A2 by combing the THS6012 datasheet. I came across Figure 42, Source Resistance vs Noise Factor, which is delightfully confusing.
Why…
Part Number: THS6012 Hello,
1°/ I would like to know the thermal resistances of the Power Pad Plastic SO (DWP) Package and the Microstar Junior (GQE) package.
According to you, from a thermal point of view, which package is best ?
2°/ I'm using…
Part Number: THS6012 Providing a link to these external noise macro's to correct the THS6012 noise model. This is a TINA V9 file.
2705.TINA Noise Sources revC (1).TSC
Part Number: THS6012 Other Parts Discussed in Thread: THS3491 I have still have thermal shutdown with my design.
I have 2 questions :
1°/ What is the thermal resistance Junction to Top plastic case ?
2°/ What is the tolerance of the thermal shutdown…
Part Number: THS6012 So I was planning on using those 1/f macro's that Bill Sands did some years back - I know I have seen a succinct description of how to set up the 3 parameters inside, and the header is pretty clear also, but is the good reference…
Part Number: THS6222 Other Parts Discussed in Thread: THS6012 , THS6022 , BUF634A , LME49724 , TINA-TI , THS4151 , THS4150 , THS4552 Hi, I am looking for a balanced output amplifier of a signal generator 0 - 300kHz, Vcc +/-16V, output total Rload 200R…
Part Number: THS6012 Hello all,
I'm trying to determine the output impedance for the THS6012IDWP device
Ref. datasheet page 5 shows Vo output voltage swing Differential of RL =50 ohms and Io Output Current RL = 25 ohms while page 6 shows Output Resis…
Part Number: THS6012 My question is related to an increase in voltage at the end of a “transmission line”.
First, I don’t want to confuse you. There are 2 signals that are referred to in the attached schematics.
A “W” beam signal and a “N” beam…
Other Parts Discussed in Thread: THS6012 , LMH6521 After soldering THS6012 and powering it up for first time it starts to heat immediately. First suspect is pad - can it be connected to GND? Or left floating? I connected it to GND. Is that ok?
There…
