Part Number: THS6182 Hi,
I am using THS6182 IC as a normal amplifier with Non inverting configuration. I have connected Bias 1, bias 2 and Iadj pins to GND. I am facing heating problem when switched ON even with no Load connected. The IC is supposed…
Part Number: THS6182 Hello,
I'm using 2 THS6182 as a power amplifier to amplify sine wave in 220KHz,
while testing the circuit I found a DC offset of 2V yet my inputs are AC coupled and measured and didn't have any DC offset between them.
my load…
Part Number: THS6182 Hi, Kai Zhao Alec Saebeler Sima Jalaleddine - we replaced the 1K resistor feeding the IADJ pin with a 0R resistor as proposed - no change.
Summary so far: THS6182 overshoots when changing state from "disable" to "full bias", therefore…
Part Number: THS6182 Other Parts Discussed in Thread: THS6132 IADJ pin - what if I connect it to GND via a ~1K resistor?
What if I connect it to (-)150mV via a ~1K resistor?
Thanks!
Part Number: THS6182 Hello team,
Customer is trying to use THS6182 in LTSpice since rest of their system has been modeled there.
Do we have unencrypted SPICE model available or some other way to be able to model the part in LTSpice?
Thank you!
Part Number: THS6182 Hello team,
Customer plans to use THS6182 in full bias mode. They are very limited on space hence wondering if they can connect the bias pins directly to ground without any resistor and cap. The EVM for the part has a series resistor…
Part Number: THS6182 I have an application where the BIAS-1 and BIAS-2 lines rise very slow and I wish to know if the THS6182 can handle it or it may create any problems.
If those inputs are Schmidt-triggered I guess there will be no problem, but this…
Hello,
I have a circuit which uses THS6182DWP. When turning the chip ON (Bias1, Bias2=0,0) there is an oscillation of 1.5 to 3Mhz on the output.
Here is the simplified circuit which behaves similar to the final one:
Vcc=24V
Gnd=0V
Ceramic…
Other Parts Discussed in Thread: THS6182 , THS3091 Hi,
My customer wants to using THS6182 in G3 PLC for power line driver. Their system requires the driver has capability to drive 20ohm to 20Vpp. Such the amplifier should be able to deliver 1A output…
