Other Parts Discussed in Thread: THS6214 For operating a THS6214 between +/-12V power and for maximum bandwidth, should Iadj be connected to ground, +12V or -12V and what is the resistor value ? I assume the Bias would be set to Full for the maximum bandwidth…
Other Parts Discussed in Thread: THS6214 Spectrally flat white noise is applied to the amplifier but the amplifier output has a 5dB roll-off. The noise is band limited from 135KHz to 115MHz and it appears flat on a spectrum analyzer within a few tenths…
I am lookng for an appliactions document that better describes this IC and pin connections.
one specificly is Pin7 IADJ, there is no mention in the data sheet of how to best connect this pin.
is there a better detailed application doument or Evaluation…
Other Parts Discussed in Thread: THS6214 Hello, I'm Jin
I have a question about THS6214.
I can't find block diagram or pin description.
So, if you have it, please let me have.
Or if you have any application schematics
It will also helpful for me…
Hello Ervin,
You will notice the the THS6212 and the THS6214 are marketed differently (one is PLC while the other is DSL) although they are essentially the same part with a different number of channels. Both parts can be used in either application. Although…
Hi user5102208,
This looks like the model for THS6214, since there are 4 amplifiers. Is that the part you are actually using? It has conflicting labels and pin numbers, since pin 21 labeled NC4 instead of Vs+ and pin 10 labeled as NC2 instead of Vs-…
Other Parts Discussed in Thread: THS6204 , THS6214 Hi,
Is there any source for a spice model for THS6204 or THS6214?
Thanks a lot in advance for answering!
Regards, taabt
