Part Number: TIEVM-VIENNARECT Tool/software: Hi,
Part Used: TMS320F28379DPTPS
I am observing noise on the ADC input for output voltage sensing. I have attached the waveform for your reference.
Could you please confirm whether this noise could cause any…
Part Number: TIEVM-VIENNARECT Other Parts Discussed in Thread: SFRA Tool/software: Hi,
Test Condition: Input Voltage: 80 VAC RMS, Output Set Voltage: 200 V, Load: 300 ohms.
During Build 3 testing with the reference set voltage of 200 V, the output voltage…
Part Number: TIEVM-VIENNARECT Tool/software: Hi,
Test Condition:
I encountered output voltage oscillations in the steady state for the Build 3 configuration. It works fine up to 80% of the reference value, but beyond that, it starts oscillating, and…
Part Number: TIEVM-VIENNARECT Tool/software: Hi,
Test Condition:
I encountered output voltage oscillations in the steady state for the Build 3 configuration. It works fine up to 80% of the reference value, but beyond that, it starts oscillating, and…
Part Number: TIEVM-VIENNARECT Tool/software: Hi,
I am using a 3-phase Vienna converter (TIEVM-VIENNARECT).
The issue is that when I apply an input of 120 Vacrms, 3-phase, 50 Hz, the input voltage displayed in Code Composer Studio is around 116 VAC.
…
Part Number: TIEVM-VIENNARECT Other Parts Discussed in Thread: LAUNCHXL-F28379D , SYSCONFIG
When I use LAUNCHXL-F28379D replace F28379D C2000 Delfino MCU controlCARD, I try to write 1 in Cleartrip for my open loop, no pwm output in my PWM1A pin. What should…
Part Number: TIEVM-VIENNARECT Other Parts Discussed in Thread: TIDM-1000 Hi Team,
Here're two issues from the customer need your help:
1. In the program given by TI, is the meaning of each variable provided?
2. Can the resistance value of the third…
Part Number: TIEVM-VIENNARECT Hello,
I am curious if this the only 3-phase PFC evaluation board (for any topology) TI makes? I found some reference designs but I couldn’t seem to find any other evaluation boards.
Thanks,
Adam
Part Number: TIEVM-VIENNARECT Dear team:
One of my customers would like help with some problems in the use of the suite:
offsetCalCounter=0;
*iL1MeasOffset=0;
*iL2MeasOffset=0;
*iL3MeasOffset=0;
*v1MeasOffset=0;
*v2MeasOffset=0;
…
