Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TL072H Other Parts Discussed in Thread: TLE2301 Hi team,
I'm FAE from Shenzhen AA1 team.
My customer Holatek (JMGO) is using TCA0372 and L2720 in their projector.
The amplifiers are used to drive galvanometer cooperated with DAC, the …
Part Number: TL072H I just want to make sure I understand the EMIRR specs in, for instance, TL07xH DS.
The SBOA128A document “EMI Rejection Ratio of Operational Amplifiers” says:
“ … a distinction between EMIRR IN+ and EMIRR will be made here…
Part Number: TL072H Other Parts Discussed in Thread: TL072 Hello,
While looking at the datasheet for TL072HIPWR, I was unable to find the following information:
Supply Current
Equivalent Input Noise Voltage
Input Impedance
I'm looking at it in reference…
Part Number: TL072H Other Parts Discussed in Thread: TINA-TI Hello Engineers,
When I use the P spice (TL07XH_TL08XH - Rev. B) then the input offset looks to be 9 mV in a simple unity gain application at +/- 5V supply.
This value is outside the max limits…
What you have sounds like the TL072H. It is a CMOS device, so it has rail-to-rail outputs, with higher noise. (The datasheet specifies this separately for the TL072H variant.)
Hello Yang,
Clemens Ladisch said: similar to the CMOS TL072H device.
Not TL072H device.
Typical current is 4.6mA per TL052 data sheet. The decreased current is (250mA - 187mA) = 63mA or 4mA per TL052. The PCN change actually lowered typical current by a…
Part Number: TL062 Other Parts Discussed in Thread: TL072H , TL082H , OPA2990 , LM358B , Hey team,
I'm trying to recommend a replacement for the TL062CPWR because my customer wants to move to a MSOP package for supply chain reasons. I found the TL072H and…
Part Number: LM358 Other Parts Discussed in Thread: TLV9002 , TL072H Hi Team,
My customer use LM358 as differential op for over current protection. However they occur an issue for differential application. The blow is their schematic and issue description…
Hi Ore
Further to my last, having rummaged more, I note that the TL072H is a candidate : recovery time (as you observe) good enough, no phase reversal, 100 mV from rails with 10 k load and OK for 5V single supply operation.
Is there a method for preparing…
