Part Number: TL081 Tool/software: Hello,
We have received and mounted on our products a new batch of this reference.
And we observe a different behavior during the ICT test of our products.
On previous batches, we able to test the clamping diode between…
Part Number: TL081 Tool/software: Hi,
Customer would like to confirm if this part TL081CP that the zero point can be adjusted as stated in the manual.
Please help to advise.
Thanks
Regards
Part Number: TL081 Other Parts Discussed in Thread: TL061 , TL031 , TLE2021 Hello
PDIP(8) is used as a replacement for obsolete products. Initially, we considered TL081IP. but Regarding the Temperature coefficient of input offset, we calculated it from the…
Part Number: TL081 （ 2 nd additional Q ）
Input Offset Voltage Null Circuit of TL081IP
Adjust the trimmer resistor from 100kΩ to 10k Ω and connect the center tap directly to Vcc- without going through 1.5k Ω .
Please let me know if connecting…
Part Number: TL081 Other Parts Discussed in Thread: UA741 , Hello
I am considering adopting TL081IP and uA741CP. Please let me know the following information as it is not mentioned in the data sheet. (1)Power Dissipation (ABSOLUTE MAXIMUM RATINGS) (2) When…
Part Number: TL081 Other Parts Discussed in Thread: LM741 , TLV9301 Additional question.
I am also considering adopting LM741CN. Please let me know the following information as it is not mentioned in the data sheet. (1) When LM741 is used at -20°C to 80°C…
Part Number: TL081 Other Parts Discussed in Thread: TIDA-010065 , Hello,
I have a TL081 op-amp and I would like to supply its VCC and VEE pins with +/- 12 V. Normally I was going to use TPS65130RGER to generate +/- 14 V and then use LDO's to drop from …
Part Number: TL081H Other Parts Discussed in Thread: TL081 , TL084H , TL084 Hello,
From datasheet SLOS081M is appears that output swing, especially positive for the new TL081H is close to the rail (500mV).
Old TL081 can go only 1.5V from the rails.
However…
